00198382-03_UM_SIPLACE-CA4-V2_EN.pdf - 第176页

4 Setting up and commissioning Instruction manual SIPLACE CA4 V2 4.3 Setting up the placement mac hine From software versio n 713.0 Edition 12/2019 176 4.3.7 Machine foot clearances and the st ationary PCB conveyor ed ge…

100%1 / 322
Instruction manual SIPLACE CA4 V2 4 Setting up and commissioning
From software version 713.0 Edition 12/2019 4.3 Setting up the placement machine
175
Now use the fork-lift to carefully lower the placement machine until the machine feet touch
the floor evenly. There should always be a second person present to ensure that the place-
ment machine remains stable while it is being lowered. You may need to loosen the outer ma-
chine feet clamp slightly.
Continue to carefully lower the placement machine, until the outer machine feet touch the
height adjustment setting screws M24x2x120 (item 3 in fig. 4.3 - 7
, page 173).
Make sure that the middle machine feet (see item 2 in fig. 4.3 - 4, page 170) do not yet touch
the ground. If necessary, screw the middle machine feet back into the placement machine or
spacer a little.
4
PLEASE NOTE
For a description of how to perform final adjustment on the placement machine, refer to
the section 4.3.8.1
, page 178.
4 Setting up and commissioning Instruction manual SIPLACE CA4 V2
4.3 Setting up the placement machine From software version 713.0 Edition 12/2019
176
4.3.7 Machine foot clearances and the stationary PCB conveyor edges
Spacing of machine feet for single lane conveyor
4
Fig. 4.3 - 8 Spacing of machine feet for single lane conveyor in millimeters
Fixed conveyor side at maximum
right position
a
.
a) The value depends on the position of the fixed side. All dimensions in millimeters.
Fixed conveyor side at maximum
left position
a
.
Instruction manual SIPLACE CA4 V2 4 Setting up and commissioning
From software version 713.0 Edition 12/2019 4.3 Setting up the placement machine
177
4.3.7.1 Spacing of machine feet for dual lane conveyor
4
Fig. 4.3 - 9 Spacing of machine feet for dual lane conveyor in millimeters
Fixed conveyor side at maxi-
mum right position
a
.
a) The value depends on the position of the fixed side. All dimensions in millimeters.
Fixed conveyor side at maxi-
mum left position
a
.