00198382-03_UM_SIPLACE-CA4-V2_EN.pdf - 第219页

Instruction manual SIPLACE CA4 V 2 5 Tasks at the placement machi ne From software version 713.0 Ed ition 12/2019 5.7 Indicator lamps w ith horn 219 5.7.2 Customized configuration of indicator lamp  Click on " Sett…

5 Tasks at the placement machine Instruction manual SIPLACE CA4 V2

5.7 Indicator lamps with horn From software version 713.0 Edition 12/2019

218

5.7.1.3 Configuration of two-color indicator lamp and audio signal (optional)

Fig. 5.7 - 3 Configuration of two-color indicator lamp and audio signal

Instruction manual SIPLACE CA4 V2 5 Tasks at the placement machine

From software version 713.0 Edition 12/2019 5.7 Indicator lamps with horn

219

5.7.2 Customized configuration of indicator lamp

 Click on "Settings" in the toolbar of the station software .

 Click on "User" .

 Go to Customized configuration of indicator lamp and click on Configure...

–The Lamp configuration tool will start.

Fig. 5.7 - 4 Lamp configuration tool

This tool is used to adjust the indicator lamp settings to your application case. Both the lamps and

the buzzer signals can be individually configured.

 Restart the machine after changing the settings, so that the new configuration is enabled.

If the settings are not only to be used on the current placement machine, you will need to distribute

the configuration via the programming system

 Go to Customized configuration of indicator lamp and click on Distribute...

The indicator lamp settings valid on this placement machine will be sent to the programming sys-

tem and from there transferred to all placement machines in this line. These settings will then be

valid for all placement machines with the same indicator lamp configuration.

5 Tasks at the placement machine Instruction manual SIPLACE CA4 V2

5.8 Shift changeover From software version 713.0 Edition 12/2019

220

5.8 Shift changeover

5.8.1 Shift changeover tasks

 Splice the tapes early. The feeder modules do not have to be refilled as soon as the new shift

starts. This minimizes extended down times.

 At the shift change, pass important information on to the next operator. This includes, for in-

stance, changes to the placement program. Also read through the list of the descriptions of

the steps to take in section 5

, page 193.

 Carry out a setup check.

Make sure that the feeder modules are equipped with the correct components, that they are

at the correct locations in the component trolley and that the conveyor increment is set cor-

rectly.

Clean the following line assemblies:

 Empty the placement machine reject bin and carefully vacuum the area around the reject bin.

 Empty the SWS reject bin and carefully vacuum the area around the reject bin.

 Carefully vacuum the nozzle changer, feeder modules and the component trolley.

 Empty the waste tape container. Follow the safety instructions given in section 5.8.2, page

221