00198382-03_UM_SIPLACE-CA4-V2_EN.pdf - 第268页
6 Component handling Instruction manual SIPLACE CA4 V2 6.2 Component trolley From software version 713.0 Edition 12/2019 268 6.2.2 Description In the standard version, t he tape reel cont ainer (item 3 in fig . 6.2 - 3 )…
Instruction manual SIPLACE CA4 V2 6 Component handling
From software version 713.0 Edition 12/2019 6.2 Component trolley
267
6.2.1 Structure
The component trolley essentially consists of the chassis, the changeover table for holding the
feeder modules, the tape reel container and the waste tape container.
6
Fig. 6.2 - 3 Component trolley, SIPLACE X-Series, front and rear view
(1) Chassis
(2) Changeover table
(3) Tape container
(4) Gap for accommodation of setup lists
(5) Waste tape container
(6) Handle
(7) Hand guard
6
6
CAUTION
Observe the safety instructions!
Observe the safety instructions in section 5.8.2, page 221 when you pull the tape re-
ject bin out of the component trolley.
CAUTION
Risk of breaking handles!
Risk of breaking handles when transporting the component trolley.
When transporting the component trolley, do not lift it by its handles.
Only use the handles to push the component trolley.
Use a fork-lift if you want to conveyor the component trolley or lift it off the pallet.
6 Component handling Instruction manual SIPLACE CA4 V2
6.2 Component trolley From software version 713.0 Edition 12/2019
268
6.2.2 Description
In the standard version, the tape reel container (item 3 in fig. 6.2 - 3) holds tape reels up to a size
of 17" (432 mm).
There are two 5 mm wide gaps on the left and right, between the tape container and the compo-
nent trolley (item. 4 in fig. 6.2 - 3
, page 267) for holding setup lists.
The pullout waste tape container can be found beneath the chassis (item 5 in fig. 6.2 - 3
, page
267
). The cut waste tape travel down a chute into the waste tape container, which must be emptied
as it fills up.
The handles (item 6 in fig. 6.2 - 3
, page 267) can be folded up or down.
6
PLEASE NOTE
All component trolleys must be docked onto the
placement machine in order to operate it.
Fill any free locations with dummy feeder modules as described in
section 2.6.5
, page 83.
Instruction manual SIPLACE CA4 V2 6 Component handling
From software version 713.0 Edition 12/2019 6.2 Component trolley
269
6.2.3 Technical data
6
6
Length x width 727 x 592 mm²
752 x 592 mm² with waste container
Height of the changeover table 890 mm for 900 mm PCB conveyor height
920 mm for 930 mm PCB conveyor height
940 mm for 950 mm PCB conveyor height
PCB conveyor height 900 mm ± 15 mm (option)
930 mm ± 15 mm (standard)
950 mm ± 15 mm (SMEMA option)
Height of handles when folded out 969 mm
Number of locations 40 (8 mm X tape feeder module)
Weight
Without feeder modules
With feeder module at all locations
80.4 kg
139.6 kg
Tape reel diameter
Standard
Maximum
Up to 432 mm (17")
483 mm (19")