00198382-03_UM_SIPLACE-CA4-V2_EN.pdf - 第170页
4 Setting up and commissioning Instruction manual SIPLACE CA4 V2 4.3 Setting up the placement mac hine From software versio n 713.0 Edition 12/2019 170 4 Fig. 4.3 - 4 Placement machine feet 4 (1) Outer machine fo ot, 4 x…
Instruction manual SIPLACE CA4 V2 4 Setting up and commissioning
From software version 713.0 Edition 12/2019 4.3 Setting up the placement machine
169
4
With the fork-lift, raise the placement machine approximately 35 cm. This prevents the risk of
any injuries to your feet if the machine feet are unintentionally lowered.
The placement machine stands on 6 feet.
– 4 outer machine feet (item 1 in fig. 4.3 - 4
, page 170 )
– Outer machine feet for the PCB conveyor heights 900,930 and 950 mm, length
439 mm, Item no. 03000890-02 (item 1 in fig. 4.3 - 3
).
– 2 middle machine feet (item 2 in fig. 4.3 - 4
, page 170) with 2 spacers (item 3 and 4 in fig. 4.3
- 4, page 170) for height adjustment, where necessary.
4
Fig. 4.3 - 3 Outer machine feet - two versions (dimensions in millimeters)
WARNING
Risk of damage due to one-sided loading!
One-sided loading of the machine feet e.g. from tilting the machine, can lead to deforma-
tion of the machine feet fixtures.
Make sure that the forks are evenly loaded when you lift the placement machine.
Use a firm support layer between the forks and the placement machine.
Enlist the help of a second person to watch while you lift the placement machine and
make sure that the placement machine does not tip over to one side.
4 Setting up and commissioning Instruction manual SIPLACE CA4 V2
4.3 Setting up the placement machine From software version 713.0 Edition 12/2019
170
4
Fig. 4.3 - 4 Placement machine feet
4
(1) Outer machine foot, 4 x, 2 versions (see fig. 4.3 - 3, page 169 )
(2) Middle machine foot, 2 x
(3) Spacer on the side of the power supply unit
(2)
(2)
(1)
(1)
(1)
(1)
(3)
Instruction manual SIPLACE CA4 V2 4 Setting up and commissioning
From software version 713.0 Edition 12/2019 4.3 Setting up the placement machine
171
4.3.6.1 Presetting the height of the middle machine feet
The middle machine feet are initially preset. The spacer must be screwed to the correct position
on the underside of the machine: this will vary according to the height of the machine.
Setting a board conveyor height of 900 mm 4
You need a spacer for a board conveyor height of 900 mm.
Make sure that the 90 mm side of the spacer is vertically aligned and the hole for the middle
machine foot indicates downwards.
4
4
4
4
4
4
4
4
4
4
4
4
Fig. 4.3 - 5 Aligning the spacer for a conveyor height of 900 mm
4
(1) Spacer height of 90 mm
(2) Middle machine foot
(3) Lock nut M24
(4) Hexagon socket head screw M12x80, 4 x