00198382-03_UM_SIPLACE-CA4-V2_EN.pdf - 第266页
6 Component handling Instruction manual SIPLACE CA4 V2 6.2 Component trolley From software version 713.0 Edition 12/2019 266 6 Fig. 6.2 - 2 Component trolley , SIPLACE X-Series, with a PCB conveyor height of 950 mm 6 (1)…
Instruction manual SIPLACE CA4 V2 6 Component handling
From software version 713.0 Edition 12/2019 6.2 Component trolley
265
6.2 Component trolley
Item no. 00119722-xx SIPLACE X-Series component trolley
Four SIPLACE X-Series component trolleys can be docked onto SIPLACE CA4 V2 placement
machines.
6
Fig. 6.2 - 1 Component trolley locations
(1) Location 1
(2) Location 2
(3) Location 3
(4) Location 4
(T) Direction of PCB conveyor
The component trolleys are stand-alone modules that can be set up with feeders at an external
setup area. This means that the production process only has to be interrupted briefly in order to
change the component trolley.
(1)
(4)
(2)
(3)
6 Component handling Instruction manual SIPLACE CA4 V2
6.2 Component trolley From software version 713.0 Edition 12/2019
266
6
Fig. 6.2 - 2 Component trolley, SIPLACE X-Series, with a PCB conveyor height of 950 mm
6
(1) Holes in the guide columns for the PCB conveyor heights of 900, 930 and 950 mm.
(2) Support block
(3) Changeover table
(4) Contact for switching the safety switch in the COT insert
Instruction manual SIPLACE CA4 V2 6 Component handling
From software version 713.0 Edition 12/2019 6.2 Component trolley
267
6.2.1 Structure
The component trolley essentially consists of the chassis, the changeover table for holding the
feeder modules, the tape reel container and the waste tape container.
6
Fig. 6.2 - 3 Component trolley, SIPLACE X-Series, front and rear view
(1) Chassis
(2) Changeover table
(3) Tape container
(4) Gap for accommodation of setup lists
(5) Waste tape container
(6) Handle
(7) Hand guard
6
6
CAUTION
Observe the safety instructions!
Observe the safety instructions in section 5.8.2, page 221 when you pull the tape re-
ject bin out of the component trolley.
CAUTION
Risk of breaking handles!
Risk of breaking handles when transporting the component trolley.
When transporting the component trolley, do not lift it by its handles.
Only use the handles to push the component trolley.
Use a fork-lift if you want to conveyor the component trolley or lift it off the pallet.