00198505-01_SM_SIPLACE_SmartFeeder_EN.pdf - 第116页
7 Repairs to SmartFeeder 8 mm X 7.10 Tamp wheel 116 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 ► Tilt the feeder module to the right and hold the Al- len screw on the spiral gear with one finger. ► Fasten th…
7 Repairs to SmartFeeder 8 mm X
7.10 Tamp wheel
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 115
► Fit the tamp wheel on the axis, as shown in the
diagram.
► Place the top washer onto the tamp wheel.
► Insert the spiral gear as shown in the diagram.
7 Repairs to SmartFeeder 8 mm X
7.10 Tamp wheel
116 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
► Tilt the feeder module to the right and hold the Al-
len screw on the spiral gear with one finger.
► Fasten the slotted screw.
Use a flat-bladed screwdriver for this.
► Fasten the Allen screw to the spiral gear on the
left side.
Use a size 4 Allen key with 0.9Nm for this.
► Fasten the wiper (see 7.11.2 "Fitting the wiper 8
mm X " [}118]).
► Fasten the rocker (see 7.9.2 "Fitting the rocker
assembly" [}110]).
► Fit the bearing cap onto the foil stripping unit, as
shown.
► Fasten the bearing cap with the three screws
shown(1). Use a Phillips screwdriver with 0.9 Nm
for this.
► Fasten the left side cover (see 7.3.2 "Fitting the
left side cover" [}83]).
7 Repairs to SmartFeeder 8 mm X
7.11 Wiper
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 117
7.11 Wiper
Required spare part
Fig.35: Wiper for foil disposal X8Smart
Feeder module Item no. Designation
SmartFeeder 8mm X 03106790Sxx Wiper for foil disposal X8Smart
03071821-xx SN 213307-H-M2.5 x 3-A2-70
Required tools
●
Phillips screwdriver, small
●
Tweezers
7.11.1 Removing the wiper 8 mm X
► Carefully place the feeder module with the left
side down on a stable, level and clean surface.
► Insert the Phillips screwdriver through the open-
ing in the rocker(1).
► Remove the Phillips screw(2), which is fastening
the stripping device.