00198505-01_SM_SIPLACE_SmartFeeder_EN.pdf - 第129页
7 Repairs to SmartFeeder 8 mm X 7.15 Control board Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 129 7.15.1 Removing the control board ► Carefully place the feeder module with the left side down on a stable, le…
7 Repairs to SmartFeeder 8 mm X
7.15 Control board
128 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
7.15 Control board
CAUTION
Electrostatic charge
When removing and fitting the control board, observe the currently applicable ESD
guidelines.
Required spare part
Fig.40: Control board X8Smart V2
Feeder module Item no. Designation
SmartFeeder 8mmX (V1)
00141370-01
03101127-xx Control board X8Smart
SmartFeeder 8mmX (V2)
00141370-02
03124276-xx Control board X8Smart V2
SmartFeeder 8mm X splice sensor (V1)
00141390-01
03101127-xx Control board X8Smart
SmartFeeder 8mm X splice sensor (V2)
00141390-02
03124276-xx Control board X8Smart V2
Required tools
●
Phillips screwdriver 0.9Nm
●
TORX screwdriver 0.6Nm and 0.2 Nm, size T8
7 Repairs to SmartFeeder 8 mm X
7.15 Control board
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 129
7.15.1 Removing the control board
► Carefully place the feeder module with the left
side down on a stable, level and clean surface.
► Remove the three Phillips screws marked in the
picture(1), which fasten the control board to the
right side cover.
► Carefully remove the TORX screw shown in the
diagram(2), which fastens the EDIF connector to
the control board.
Use a size 8 TORX screwdriver for this.
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Remove the left side cover (see section 7.3.1
"Removing the Left Side Cover" [}83]).
► Remove the EDIF connector.(1)
► Loosen the 6 connections shown in the dia-
gram.(2 – 7)
► If there is a splice sensor fitted in the feeder mod-
ule, open the connection to the splice sensor
cable.(1)
► Remove the control board.
7 Repairs to SmartFeeder 8 mm X
7.15 Control board
130 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
7.15.2 Fitting the control board
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Insert the control board into the feeder module as
shown in the diagram.
Align the position of the control board using the 3
holes in the control board and the 3 holes in the
side cover.
► Push the flat ribbon cable for the splice sensor as
far as the stop into the connection shown in the
diagram.
Make sure that the contacts are on the underside
of the cable and that the brown side of the cable
can be seen on the top.
► Lock the connection.
► Insert the connectors shown in the diagram(1-3)
into the relevant connections on the control
board.