00198505-01_SM_SIPLACE_SmartFeeder_EN.pdf - 第221页

9 Repairs to SmartFeeder 12 mm X / 16 mm X 9.11 Foil disposal blade Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 221 9.11 Foil disposal blade Required spare part Fig.80: Foil disposal blade Feeder module Item…

100%1 / 286
9 Repairs to SmartFeeder 12 mm X / 16 mm X
9.10 Tape Disposal Flap
220 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
9.10.1 Removing the Flap
► Carefully place the feeder module with the left-
hand side down on a stable, level and clean sur-
face.
► Remove the screwed axle on the flap(1). Use a
size 3 Allen key for this.
► Remove the flap sideways from the feeder mod-
ule.(2)
9.10.2 Fitting the Flap
► Carefully place the feeder module with the left-
hand side down on a stable, level and clean sur-
face.
► Push the flap, as shown, side ways into the
feeder module.(1)
► Close the flap.
► Fasten the flap with the screwed axle(2). Use a
size 3 Allen key with 0.6Nm for this.
9 Repairs to SmartFeeder 12 mm X / 16 mm X
9.11 Foil disposal blade
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 221
9.11 Foil disposal blade
Required spare part
Fig.80: Foil disposal blade
Feeder module Item no. Designation
SmartFeeder 12mm X
SmartFeeder 16mm X
0341370Sxx Blade
Required tools
●
TORX screwdriver 0.6Nm, size T8
●
Tweezers
WARNING
Risk of injury
The edge of the blade is very sharp. Make sure that you always use a pair of tweezers
when removing and fitting the blade.
9.11.1 Removing the Blade
► Carefully place the feeder module with the right-
side side down on a stable, level and clean sur-
face.
► Open the flap at the back of the foil container
► Remove the screw fastening the blade.(1)
Use a size 8 TORX screwdriver for this.
► Remove the blade with a pair of tweezers.(2)
9 Repairs to SmartFeeder 12 mm X / 16 mm X
9.12 Leaf Spring
222 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
9.11.2 Fitting the Blade
► Use a pair of tweezers to insert the blade.(1)
Attention:
the blade is very sharp.
► Screw the blade tight.(2)
Use an RF2.5x6 screw and a size 8 TORX
screwdriver with 0.6Nm for this.
► Close the flap.
9.12 Leaf Spring
Required spare part
Fig.81: Leaf spring
Feeder module Item no. Designation
SmartFeeder 12mmX
SmartFeeder 16mm X
03082505Sxx Leaf spring tape infeed X12/X16 V2
Required tools
●
Phillips screwdriver 0.6Nm
●
TORX screwdriver 0.6Nm, size T8
●
Flat or universal pliers