00198505-01_SM_SIPLACE_SmartFeeder_EN.pdf - 第198页
9 Repairs to SmartFeeder 12 mm X / 16 mm X 9.6 Splice Sensor 198 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 For the splice sensor dummy: ► Insert the 4-pin connector for the splice sensor cable into the spli…
9 Repairs to SmartFeeder 12 mm X / 16 mm X
9.6 Splice Sensor
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 197
For the splice sensor:
► Carefully lever the connector of the splice sensor
cable out of the connection. Use a small screw-
driver or pair of tweezers to help you.
For the splice sensor dummy:
► Pull the splice sensor cable out of the splice
sensor dummy.
9.6.3.2 Fitting the Cable Splice Sensor
For the splice sensor:
► Fit the 4-pin connector for the splice sensor cable
into the splice sensor, as shown in the diagram.
9 Repairs to SmartFeeder 12 mm X / 16 mm X
9.6 Splice Sensor
198 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
For the splice sensor dummy:
► Insert the 4-pin connector for the splice sensor
cable into the splice sensor dummy, as shown in
the diagram.
► Fix the splice sensor (dummy) using the marked
screw and 0.6 Nm. (1).
► Plug the 3-pin connector for the splice sensor
cable into the connection on the control
board.(2)
► Run the cable in the cable duct as shown in the
diagram.
► Fix the cable with the cover cord (rubber) in the
cable duct.(3)
We advise that you use a pair of tweezers for
this.
► Fasten the left side cover (see 9.3.2 "Fitting the
Left Side Cover" [}184].
9 Repairs to SmartFeeder 12 mm X / 16 mm X
9.7 Drives and gears
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 199
9.7 Drives and gears
9.7.1 Shifted gear for tape drive
Required spare parts
Fig.69: ETP gear set tape X12/16
Feeder module Item no. Designation
SmartFeeder 12mm X
SmartFeeder 16mm X
03095425- xx ETP gear set tape X12/16
Tools and equipment required
●
Phillips screwdriver 0.6Nm
●
TORX screwdriver 0.6Nm, size T8
●
Circlip pliers for outer rings 3-10 mm
●
Tweezers
●
Polylub GLY 801 (grease)
●
Ethanol
NOTICE
Avoiding gear damage
If your feeder module has a bronze shifted gear, this will need to be completely replaced
with a plastic shifted gear.
The use of bronze and plastic shifted gears at the same time is not permitted and can
cause damage to the gear unit.
Shifted gears may not be replaced one at a time. Always replace the complete shifted gear
assembly.