00198505-01_SM_SIPLACE_SmartFeeder_EN.pdf - 第145页

8 Repairs to SmartFeeder 2x8 mm X 8.6 Splice sensor / dummy Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 145 ► Fix the splice sensor to the lane with the screws provided. ► Fit the second splice sensor in the …

8 Repairs to SmartFeeder 2x8 mm X

8.6 Splice sensor / dummy

144 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017

8.6.2 Fitting the splice sensor

NOTICE

Always fit both splice sensors.

If you want to use splice sensors for the feeder module, both lanes need to be supplied with

splice sensors.

When you connect the splice sensors, make sure that you use the right cable for the lane in

each case:

- The cable for the splice sensor on the left lane has the colors red, white and black.

- The cable for the splice sensor on the right lane has the colors red, brown and black.

► Pull the sensor cable for that lane out of the cable

duct.

► Plug the connector for the sensor cable into the

connection on the splice sensor.

► Carefully guide the sensor cable back into the

cable duct.

► Place the splice sensor onto the lane.

Make sure that you do not pinch the cable but

that it is fed into the cable duct properly.

► Push the splice sensorin the direction of the ar-

row, as far as the stop, towards the tape duct.

Make sure that the nib at the front of the splice

sensor is completely inserted into the tape duct.

8 Repairs to SmartFeeder 2x8 mm X

8.6 Splice sensor / dummy

Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 145

► Fix the splice sensor to the lane with the screws

provided.

► Fit the second splice sensor in the other lane.

The procedure is the same as that for the first

splice sensor.

After installation, the splice sensors will be automatic-

ally recognized and do not require any additional activ-

ation.

8.6.3 Removing the splice sensor

► Remove the screw fastening the splice sensor to

the lane.

8 Repairs to SmartFeeder 2x8 mm X

8.6 Splice sensor / dummy

146 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017

► Pull the splice sensor out of the tape duct, in the

direction of the arrow.

► Lift the splice sensor out of the lane.

Make sure that you do not stretch the cable too

much.

► Pull the connector for the sensor cable out of the

connection on the splice sensor.

► Remove the splice sensor.

► Insert the sensor cable back into the cable duct.

If you want to use a dummy splice sensor, remove the

second splice sensor. The procedure is the same as

that for the first splice sensor.