00198505-01_SM_SIPLACE_SmartFeeder_EN.pdf - 第247页
10 Repairs to SmartFeeder 24 - 104 mm X 10.6 Splice sensor Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 247 ► Fix the splice sensor (dummy) with the marked screw. Use a Phillips screwdriver with 0.6 Nm for thi…
10 Repairs to SmartFeeder 24 - 104 mm X
10.6 Splice sensor
246 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
10.6.3.2 Fitting the filler piece
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Place the filler piece as shown on the feeder
module.(1)
► Run the splice sensor cable as marked in the dia-
gram, in the cable duct.(2)
► Plug the connector for the splice sensor cable
into the connection on the control board.(3)
► Place the feeder module in a stable, upright posi-
tion.
► Lift the splice sensor (dummy) as shown into the
filler piece.(1)
Make sure that the 2 fixing pins point to the front
and the 3 contact pins to the back.
► Push the splice sensor (dummy) with the fixing
pins first as far as the stop, in the direction of the
arrow: to the right.(2)
► Push the filler piece as far as the stop to the right
(direction of the arrow).
When fitting the splice sensor, make sure that the
contact pins of the sensor touch the contacts on
the filler piece.
10 Repairs to SmartFeeder 24 - 104 mm X
10.6 Splice sensor
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 247
► Fix the splice sensor (dummy) with the marked
screw. Use a Phillips screwdriver with 0.6 Nm for
this.
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Fix the left side plate into place. (see 10.3.1 "Re-
moving/fitting the left side plate" [}230]).
10 Repairs to SmartFeeder 24 - 104 mm X
10.7 Drives and gears
248 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
10.7 Drives and gears
10.7.1 Shifted gear for tape drive
Required spare parts
Fig.89: ETP drive unit tape X24 Smart
Feeder module Item no. Designation
SmartFeeder 24 - 104mmX 03154797-01
03121717-xx
ETP drive unit tape X24 Smart
Seal for gears X24-104
Tools and equipment required
●
Phillips screwdriver 0.6Nm
●
TORX screwdriver 0.6Nm, size T8
●
Circlip pliers for outer rings 3-10 mm
●
Tweezers
●
Polylub GLY 801 (grease)
●
Ethanol
NOTICE
Avoiding gear damage
If your feeder module has a bronze shifted gear, this will need to be completely replaced
with a plastic shifted gear.
The use of bronze and plastic shifted gears at the same time is not permitted and can
cause damage to the gear unit.
Shifted gears may not be replaced one at a time. Always replace the complete shifted gear
assembly.