00198505-01_SM_SIPLACE_SmartFeeder_EN.pdf - 第119页
7 Repairs to SmartFeeder 8 mm X 7.12 Foil disposal flap Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 119 7.12 Foil disposal flap Required spare part Fig.36: Flap for foil stuffing unit assy. X8Smart Feeder mo…
7 Repairs to SmartFeeder 8 mm X
7.11 Wiper
118 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
► Press the rocker(3) backwards.
► Pull the stripping device(4) upwards.
► Lower the rocker again.
► Remove the stripping device.
7.11.2 Fitting the wiper 8 mm X
► Press the rocker(1) backwards.
► Insert the stripping device(2) as shown, with the
flat side facing upwards.
► Align the stripping device so that it is straight.
Make sure that the hole for the screw is visible through
the hole in the stripping device and that the individual
parts of the stuffing gear protrude through the re-
cesses (3) of the stripping device.
► Lower the rocker again.
► Use a pair of tweezers to hold the Phillips
screw(4) over the drilled hole.
► Insert the Phillips screwdriver through the open-
ing in the rocker(5).
► Hand-tighten the Phillips screw fastening the
stripping device.
7 Repairs to SmartFeeder 8 mm X
7.12 Foil disposal flap
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 119
7.12 Foil disposal flap
Required spare part
Fig.36: Flap for foil stuffing unit assy. X8Smart
Feeder module Item no. Designation
SmartFeeder 8mmX 03107505-xx Flap for foil stuffing unit assy. X8Smart
03004081-xx Shaft for D2 foil flap X8
Required tools
●
Phillips screwdriver 0.9Nm
●
TORX screwdriver 0.6Nm, size T8
7.12.1 Removing the Flap
NOTICE
Avoid confusing the foil tank panel
The foil tank panel has a barcode which uniquely identifies the feeder module. Make sure
that this sheet is not confused with another foil tank panel.
► Carefully place the feeder module with the left
side down on a stable, level and clean surface.
► Remove the right side cover (see 7.3.3 "Remov-
ing the right side cover" [}84])
► Carefully lift the foil tank panel(1) out of the base
of the feeder module.
7 Repairs to SmartFeeder 8 mm X
7.12 Foil disposal flap
120 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
► Remove the flap(2) and the shaft(3). The shaft
is only pushed into the foil tank.
► Clean the foil tank thoroughly and remove all foil
and adhesive residues before fitting the foil tank
panel back on the foil tank.
7.12.2 Fitting the Flap
► Insert the shaft(1) into the foil tank for the feeder
module.
► Push the flap(2) onto the shaft.
► Place the foil tank panel(3) onto the foil tank, as
shown.
Make sure that the foil tank panel engages with
the nibs provided at the positions marked in red.
► Fit the right side cover (see7.3.4 "Fitting the right
side cover 8" [}85]).