Service Manual SIPLACE SmartFeeder.pdf - 第181页
8 Repairs to SmartFeeder 2x8 mm X / Xi 8.5 Pickup window Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 181 8.5.1 Removing the pickup window ► Remove the 2 marked screws fa…
8 Repairs to SmartFeeder 2x8 mm X / Xi
8.5 Pickup window
180 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
Spare part required
Fig.59: Pickup window assy. SmartFeeder 2x8 mm Xi
Feeder module Position Item no. Designation
SmartFeeder 2x8 mm Xi 1, 3, 4, 6, 7 03145735-xx Tape duct with pickup window /X2x8
V2
1 03145734-xx Tape duct, prefitted /X2x8 V2
3 03145733-xx Pickup window assy. /X2x8 V2
4 00349254-xx Fitting screw
6 03077394-xx Axis pickup window /X2x8
7 03165452-xx Pressure fork /X2x8 tilt function
2 03010210-xx ISO 7045 - M2.5 x 8-A2-50-H
5 03010214-xx ISO 7045 - M2.5 x 16-A2-50-H
8 03077928-xx Pressure spring 0.85x5.1x18.3
Tools and consumables required
●
Phillips screwdriver
●
Tweezers
●
Allen key 1.5
●
Grease Klubersynt GE 14-151 tub 45g, item no. 03005735-01
8 Repairs to SmartFeeder 2x8 mm X / Xi
8.5 Pickup window
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 181
8.5.1 Removing the pickup window
► Remove the 2 marked screws fastening the rel-
evant pickup window and tape duct to the feeder
module.
► Lift the pickup window up and off, together with
the tape duct.(1)
► Also remove the pressure spring and the pres-
sure bracket, to prevent these being lost.(2)
► Remove the fitting screw fastening the pickup
window axis.
8 Repairs to SmartFeeder 2x8 mm X / Xi
8.5 Pickup window
182 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
► Loosen the axis on the pickup window(1) and
push this out of the tape duct.
► Lift the pickup window up and off.(2)
8.5.2 Fitting the pickup window
NOTICE
If using the old spare parts
If you want to use the old tape duct, clean it thoroughly before fitting, particularly around the
drilled hole into which the axis will be fitted.
Clean the pressure spring.
► Fit the pickup window onto the tape duct from
above, as shown.
► Push the axis into the tape duct, with the short
end pointing forwards.
► Fasten the axis.