Service Manual SIPLACE SmartFeeder.pdf - 第70页
6 Repairs to SmartFeeder 4 mm X / Xi 6.11 Wiper 70 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 6.11.2 Fitting the wiper 4 mm X ► Insert the wiper as shown. (1) ► Make s…
6 Repairs to SmartFeeder 4 mm X / Xi
6.11 Wiper
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 69
6.11 Wiper
Spare part required
Fig.17: Wiper for foil disposal X4Smart V2
Feeder module Item no. Designation
SmartFeeder 4mm X
SmartFeeder 4 mm Xi
03134363-xx Wiper for foil disposal X4Smart V2
03071821-xx SN 213307-H-M2.5 x 3-A2-70
Tools required
●
Phillips screwdriver, small
●
Tweezers
6.11.1 Removing the wiper 4 mm X
► Remove the rocker (see 6.9.1.1 "Removing the
rocker assembly" [}59]).
► Carefully place the feeder module with the left
side down on a stable, level and clean surface.
► Insert the Phillips screwdriver through the open-
ing in the rocker(1)
.
► Remove the Phillips screwwhich is fastening the
wiper.
► Pull the wiper diagonally upwards and out. (2)
6 Repairs to SmartFeeder 4 mm X / Xi
6.11 Wiper
70 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
6.11.2 Fitting the wiper 4 mm X
► Insert the wiper as shown.(1)
► Make sure that you can see the hole for the
screw through the wiper.(2)
► Use a pair of tweezers to hold the Phillips screw
over the hole.
► Insert the Phillips screwdriver through the open-
ing in the rocker.
► Hand-tighten the wiper.
► Fit the rocker (see 6.9.1.2 "Fitting the rocker
assembly" [}60]).
6 Repairs to SmartFeeder 4 mm X / Xi
6.12 Flap on drip tray for cover foil
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 71
6.12 Flap on drip tray for cover foil
Required spare part
Fig.18: Flap for drip tray and shaft
Feeder module Position Item no. Designation
SmartFeeder 4mmX
SmartFeeder 4 mm Xi
1 03119392Sxx Drip tray for cover foil X4Smart
2 03004081-xx Shaft for D2 foil flap X8
Tools required
●
TORX screwdriver size T8, with 0.6Nm
●
Phillips screwdriver 0.9Nm