Service Manual SIPLACE SmartFeeder.pdf - 第47页
6 Repairs to SmartFeeder 4 mm X / Xi 6.7 Drives Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 47 ► Move the feeder module to an upright and stable position. On the right-h…
6 Repairs to SmartFeeder 4 mm X / Xi
6.7 Drives
46 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
6.7.1.1 Removing the Foil Disposal Motor
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Remove the left side cover (see 6.3.1 "Removing
the Left Side Cover" [}30]).
► Remove the 3 Phillips screws(1) marked in the
diagram from the bearing cap for the foil gear.
► Lift the bearing cap(2) up with a pair of tweezers
or a small screwdriver(3)
and remove it.
► Loosen the spiral gear(4) on the foil disposal
with a size 4 Allen key(5)
.
6 Repairs to SmartFeeder 4 mm X / Xi
6.7 Drives
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 47
► Move the feeder module to an upright and stable
position.
On the right-hand side of the feeder module you can
access the bearing screw (6)
for the spiral gear.
► On the left-hand side of the feeder module, you
can hold the spiral gear(4)
, while on the right-
hand side, you can open the connection using a
size 3 flat-bladed screwdriver(7)
.
► Pull the spiral gear(4) off completely.
► Remove the two screws(8), with which the
ceramic bearing blocks(9)
are fixed on the other
side.
► Turn the feeder module on to its right side.
► Open the two screws(10), with which the motor
is fastened. Use a size 2 angled Allen key for
this.
► Use a pair of tweezers to pull the outer bearing
block(11)
off the motor shaft.
6 Repairs to SmartFeeder 4 mm X / Xi
6.7 Drives
48 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
► Carefully pull the motor(12) straight off the foil
disposal unit.
Make sure that the motor shaft is not bent when
pulled out.
► Lift the motor(12) somewhat at the back and pull
it completely out of the foil disposal unit, together
with its worm gear and the inner bearing
block(13)
.