Service Manual SIPLACE SmartFeeder.pdf - 第68页

6 Repairs to SmartFeeder 4 mm X / Xi 6.10 Tamp wheel / spiral gear 68 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 ► Tilt the feeder module to the right and hold the Alle…

100%1 / 246
6 Repairs to SmartFeeder 4 mm X / Xi
6.10 Tamp wheel / spiral gear
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 67
Coat the axis with a little grease.
► Fit the tamp wheel on the axis, as shown in the
diagram.
Coat the axis with a drop of grease.
► Place the top washer (compensating disk /d3.1
D15 t0.1, 03043774-xx) onto the tamp wheel.
► Insert the spiral gear as shown in the diagram.
6 Repairs to SmartFeeder 4 mm X / Xi
6.10 Tamp wheel / spiral gear
68 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
► Tilt the feeder module to the right and hold the
Allen screw on the spiral gear with one finger.
► Fasten the slotted screw.
Use a flat-bladed screwdriver for this.
► Fasten the Allen screw to the spiral gear on the
left side.
Use a size 4 Allen key with 0.9Nm for this.
► Fasten the wiper (see 6.11.2 "Fitting the wiper 4
mm X" [}70]).
► Fasten the rocker (see 6.9.1.2 "Fitting the rocker
assembly" [}60]).
► Fit the bearing cap onto the foil stripping unit, as
shown.
► Fasten the bearing cap with the three screws
shown(1)
. Use a Phillips screwdriver with 0.9 Nm
for this.
► Fasten the left side cover (see 6.3.2 "Fitting the
Left Side Cover" [}30]).
6 Repairs to SmartFeeder 4 mm X / Xi
6.11 Wiper
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 69
6.11 Wiper
Spare part required
Fig.17: Wiper for foil disposal X4Smart V2
Feeder module Item no. Designation
SmartFeeder 4mm X
SmartFeeder 4 mm Xi
03134363-xx Wiper for foil disposal X4Smart V2
03071821-xx SN 213307-H-M2.5 x 3-A2-70
Tools required
●
Phillips screwdriver, small
●
Tweezers
6.11.1 Removing the wiper 4 mm X
► Remove the rocker (see 6.9.1.1 "Removing the
rocker assembly" [}59]).
► Carefully place the feeder module with the left
side down on a stable, level and clean surface.
► Insert the Phillips screwdriver through the open-
ing in the rocker(1)
.
► Remove the Phillips screwwhich is fastening the
wiper.
► Pull the wiper diagonally upwards and out. (2)