Service Manual SIPLACE SmartFeeder.pdf - 第51页

6 Repairs to SmartFeeder 4 mm X / Xi 6.7 Drives Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 51 ► Tighten the left-hand side of the spiral gear (12) with a size 4 Allen …

100%1 / 246
6 Repairs to SmartFeeder 4 mm X / Xi
6.7 Drives
50 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
► Insert the motor cable connector into the connec-
tion on the control board. (8)
► Close the connection.
► Turn the feeder module onto the other side.
► Fasten the bearing blocks with the two Phillips
screws(9)
(hand-tight).
► If necessary, correct the position of the bearing
blocks.
► Make sure that the spiral gear only has grease on
the small toothed wheel and that the large
toothed wheel is free of grease. You may need to
remove any grease on the larger toothed wheel!
► Place the feeder module in a stable, upright posi-
tion.
► Insert the spiral gear(10) into the hole provided,
with the smaller toothed wheel at the front. Make
sure that the small toothed wheel of the spiral
gear engages properly with the worm gear of the
motor.
► Fasten the spiral gear (hand-tight) with the bear-
ing screw(11)
. Use a flat-bladed screwdriver to
help you.
6 Repairs to SmartFeeder 4 mm X / Xi
6.7 Drives
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 51
► Tighten the left-hand side of the spiral gear(12)
with a size 4 Allen key(13) and 0.9 Nm.
► Fit the bearing cap(14) onto the foil stripping
unit, as shown.
► Fasten the bearing cap with the three marked
screws ISO 7046-2-M2.5x 6-A2-70-H (item no
03023228-xx)(15)
, using a Phillips screwdriver
and 0.9Nm.
► Fasten the left side cover (see 6.3.2 "Fitting the
Left Side Cover" [}30]).
6 Repairs to SmartFeeder 4 mm X / Xi
6.8 Foil rocker
52 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
6.8 Foil rocker
6.8.1 Replacing the foil rocker assembly
Spare part required
Fig.10: Foil rocker assembly
NOTICE
New spare part
The new foil rocker has no metal deflector (A). The old foil rocker with metal deflector (B) is
no longer available.
Fig.11: Cable light barrier emitter
Feeder module Item no. Designation
SmartFeeder 4mm X
SmartFeeder 4 mm Xi
03136093-xx Foil rocker unit assy. X4Smart V2 (no longer avail-
able)
03226998-xx Foil rocker assembly X4Smart V3
03063591-xx Cable for light barrier emitter 2x8
Tools required
●
Flat-bladed screwdriver size 1 or tweezers
●
TORX screwdriver size T8