Service Manual SIPLACE SmartFeeder.pdf - 第198页

8 Repairs to SmartFeeder 2x8 mm X / Xi 8.7 Splice sensor / dummy 198 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 8.7.4 Fitting the Dummy Splice Sensor CAUTION During ass…

8 Repairs to SmartFeeder 2x8 mm X / Xi

8.7 Splice sensor / dummy

Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 197

► Pull the splice sensor out of the tape duct, in the

direction of the arrow.

► Lift the splice sensor out of the lane.

Make sure that you do not stretch the cable too

much.

► Pull the connector for the sensor cable out of the

connection on the splice sensor.

► Remove the splice sensor.

► Insert the sensor cable back into the cable duct.

If you want to use a dummy splice sensor, remove the

second splice sensor. The procedure is the same as

that for the first splice sensor.

8 Repairs to SmartFeeder 2x8 mm X / Xi

8.7 Splice sensor / dummy

198 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020

8.7.4 Fitting the Dummy Splice Sensor

CAUTION

During assembly, make sure that the cable is not wedged in between the base unit, the

dummy splice sensor and the side covers.

► Place the feeder module down on a stable sur-

face e.g. a single slot EDIF or place the feeder

module on a level and clean surface.

► Place the dummy sensor next to the tape duct, as

shown in the diagram.

► Swing the dummy sensor up with the tip pointing

upwards.

► Pull the cable about 4 cm out of the base unit of

the feeder module.

► Push the cable connector from the outside, side-

ways into the dummy sensor guidance.

Make sure that the cable is pushed into the

dummy sensor on the correct side, as shown.

► Push the cable into each left and right cable duct

in the base unit of the feeder module.

► Carefully swing the dummy sensor down.

Make sure that the cable is not wedged in

between the base unit, the dummy splice sensor

and the side covers.

8 Repairs to SmartFeeder 2x8 mm X / Xi

8.7 Splice sensor / dummy

Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 199

► Lower the dummy sensor completely down.

► Push the dummy sensorforwards, in the direction

of the arrow, as far as the stop.

► Fasten the dummy sensor with a screw (M2,

5x6).

Use a Phillips screwdriver for this.