Service Manual SIPLACE SmartFeeder.pdf - 第241页
8 Repairs to SmartFeeder 2x8 mm X / Xi 8.16 Handle with control panel Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 241 ► Lift the printed circuit board off the control pa…
8 Repairs to SmartFeeder 2x8 mm X / Xi
8.16 Handle with control panel
240 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
8.16.3.3 Removing the control panel, board and window for the control panel
► Carefully place the feeder module with the right side down on a stable, level and clean surface.
► Remove the left side plate (see Removing/fitting the left side plate).
► Release the removal handle lock.(1)
► Remove the two screws marked in the diagram.
Use a size T8 TORX screwdriver for this.
► Lift the cover plate a little to the side, to give you
access to the parts below.
► Pull the control panel with its board straight up
and out of the handle.(1)
► If you want to replace it, lift the control panel win-
dow up and out of the handle.(2)
If you want to replace the control panel and/ or the
board:
► Open the bar on the flat ribbon connection (1) on
the printed circuit board
► Unplug the flat ribbon cable form the connec-
tion.(2)
8 Repairs to SmartFeeder 2x8 mm X / Xi
8.16 Handle with control panel
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 241
► Lift the printed circuit board off the control panel.
8.16.3.4 Fitting the control panel, board and control panel window
► Insert the end of the flat ribbon cable (with the
blue side pointing upwards as shown) straight
into the flat ribbon connection shown on the
board, as far as the stopper.
► Close the connection and make sure that the
cable it firmly fitted.
► Place the control panel(1) as shown in the dia-
gram onto the board(2)
8 Repairs to SmartFeeder 2x8 mm X / Xi
8.16 Handle with control panel
242 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
► Insert the control panel and board vertically into
the handle. (1)
► Insert the (new) control panel window from above
into the handle.(2)
► Push the cover plate on the flat ribbon cable
along the handle, until you can see the holes for
the screws through the cover plate.
► Release the removal handle lock, if neces-
sary.(1)
► Fasten the cover plate with the two screws
marked in the diagram.
Use a size T8 TORX screwdriver with 0.6 Nm for
this.