Service Manual SIPLACE SmartFeeder.pdf - 第49页
6 Repairs to SmartFeeder 4 mm X / Xi 6.7 Drives Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 49 6.7.1.2 Fitting the Foil Disposal Motor ► Carefully place the feeder modul…
6 Repairs to SmartFeeder 4 mm X / Xi
6.7 Drives
48 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
► Carefully pull the motor(12) straight off the foil
disposal unit.
Make sure that the motor shaft is not bent when
pulled out.
► Lift the motor(12) somewhat at the back and pull
it completely out of the foil disposal unit, together
with its worm gear and the inner bearing
block(13)
.
6 Repairs to SmartFeeder 4 mm X / Xi
6.7 Drives
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 49
6.7.1.2 Fitting the Foil Disposal Motor
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Push the replacement motor(1) with worm gear
and inner bearing block(2)
carefully into the foil
stripping unit(3)
.
► When pushing it in, make sure that the motor
shaft is not bent.
► Use tweezers to carefully push the outer bearing
block(4)
onto the motor shaft.
► Apply a little grease to the worm gear(5).
Use Klübersynth GE14-151 for this.
► Push the two bearing blocks(6) into the position
shown.
► Fasten the motor with the two Allen screws
marked(7)
. Use a size 2 angled Allen key for this
(hand-tighten).
► Apply a little grease to the bearing blocks(6).
Use Klübersynth GE14-151 for this.
6 Repairs to SmartFeeder 4 mm X / Xi
6.7 Drives
50 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
► Insert the motor cable connector into the connec-
tion on the control board. (8)
► Close the connection.
► Turn the feeder module onto the other side.
► Fasten the bearing blocks with the two Phillips
screws(9)
(hand-tight).
► If necessary, correct the position of the bearing
blocks.
► Make sure that the spiral gear only has grease on
the small toothed wheel and that the large
toothed wheel is free of grease. You may need to
remove any grease on the larger toothed wheel!
► Place the feeder module in a stable, upright posi-
tion.
► Insert the spiral gear(10) into the hole provided,
with the smaller toothed wheel at the front. Make
sure that the small toothed wheel of the spiral
gear engages properly with the worm gear of the
motor.
► Fasten the spiral gear (hand-tight) with the bear-
ing screw(11)
. Use a flat-bladed screwdriver to
help you.