Service Manual SIPLACE SmartFeeder.pdf - 第201页

8 Repairs to SmartFeeder 2x8 mm X / Xi 8.7 Splice sensor / dummy Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 201 8.7.5.2 Fitting the Cable Splice Sensor ► Lay the new ca…

8 Repairs to SmartFeeder 2x8 mm X / Xi

8.7 Splice sensor / dummy

200 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020

8.7.5 Cable splice sensor

Spare part required

Fig.61: Cable splice sensor

Feeder module Item no. Designation

SmartFeeder 2x8 mm X

SmartFeeder 2x8 mm Xi

03063593-xx Cable for splice sensor X2x8

Tools required

●

Phillips screwdriver

●

TORX screwdriver size T8

8.7.5.1 Removing the Cable Splice Sensor

► Place the feeder on a stable, level and clean sur-

face.

► Remove the left and right side covers. (See 8.3.1

"Removing the Left Side Cover" [}174], 8.3.3

"Removing the Right Side Cover" [}175])

► Disconnect the connector from the main

board(1)

► Remove the seal band left and right(2).

► Remove the M2.5x6 screw from splice sensor(3)

and disconnect the cables(4).

8 Repairs to SmartFeeder 2x8 mm X / Xi

8.7 Splice sensor / dummy

Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 201

8.7.5.2 Fitting the Cable Splice Sensor

► Lay the new cables(1).

► Place the seal band left and right level with the

channel. Ensure the cables can move freely.(2)

► Reconnect the cables to the splice sensor(3).

► Refit the splice sensor using the M2 5x6

screw(4)

► Connect the connector to the main board(5).

► Fit the left and right side covers. (See 8.3.2 "Fit-

ting the Left Side Cover" [}175], 8.3.4 "Fitting the

Right Side Cover" [}176])

CAUTION

Ensure the cables are not trapped between housing, splice sensor and covers.

8 Repairs to SmartFeeder 2x8 mm X / Xi

8.8 Drives

202 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020

8.8 Drives

8.8.1 Hybrid stepping motor assembly left / right

Spare part required

Fig.62: Hybrid stepping motor assembly

Feeder module Item no. Designation

SmartFeeder 2x8mmX

SmartFeeder 2x8 mm Xi

03057582-xx Hybrid stepping motor assembly

Tools required

●

TORX screwdriver 0.6Nm, size T8

●

Phillips screwdriver 0.9Nm

●

Gauge for tape drive motor /X2x8, item no. 03080225-xx

●

Gauge for foil drive /X2x8, item no. 03080235-xx