00191369-01.pdf - 第324页
7 What schould you do ... User’s Manual S IPLACE HS-50 7.4 When you change shift Software Version SR.501.xx Edition 01/99 322 :KHQ\RXFKDQJHVKLIW Å Sp lice the tapes ea rly enou gh so that the fee der modul es do n…
User’s Manual SIPLACE HS-50 7 What schould you do ...
Software Version SR.501.xx Edition 01/99 7.3 Changing jobs
321
TIP
Have the nozzles ready in a separate nozzle box in which each compartment is labeled with the
type and color of the nozzle. This will help to prevent confusion. Do not save used plastic nozzles,
dispose of them immediately instead.
701
yellow
704
orange
705
red
711
yellow
7 What schould you do ... User’s Manual SIPLACE HS-50
7.4 When you change shift Software Version SR.501.xx Edition 01/99
322
:KHQ\RXFKDQJHVKLIW
Å Splice the tapes early enough so that the feeder modules do not have to be refilled as soon as
the new shift starts. This will prevent lead to pick-up errors and prolonged down times.
Å Inform the next operator of any important information when changing shifts when, for example,
something has been changed in the placement program or if errors have occurred more fre-
quently in certain feeder modules. Also read through the list of the descriptions of the steps to
take in section 7.6
.
Å Carry out a set-up check.
Make sure that the feeder modules are equipped with the correct components and that they
are at the correct locations in the component table.
NOTE
Hand over the line in the same state that you would want to find it in when starting your shift.
This means that:
- The rejection containers are empty.
- The waste containers are empty.
- The conveyor areas have been cleaned with a vacuum cleaner.
- Defective feeder modules in the feeder area have been replaced.
User’s Manual SIPLACE HS-50 7 What schould you do ...
Software Version SR.501.xx Edition 01/99 7.5 When you, as an operator, carry out a walk-through inspection
323
:KHQ\RXDVDQRSHUDWRU FDUU\RXWDZDONWKU RXJ K
LQVSHFWLRQ
Å Make sure that the tape is correctly placed in the springs of the 8 mm S.
Å Check to ensure that the tape foil removal container for the 8 mm S is full.
If it is full, then pull out the foil and cut it off with scissors.
NOTE
Tearing the foil instead of cutting it can lead problems with the tape removal mechanism.
Å Check to ensure that the withdrawal space on the feeder module is the right size for the com-
ponent.
Å Check to see if tape guides are being used on the feeder modules that are intended for different
tape widths.