00193922-03.pdf - 第231页
User manual SIPLAC E HF series 5 T asks on the m achine Software Vers ion SR.50x.xx 01/2006 US Edition 5.3 Carrying out a walk -through inspection 231 5 Fig. 5.3 - 2 S eparating plates in the tape container (1) Gui de ra…
5 Tasks on the machine User manual SIPLACE HF series
5.3 Carrying out a walk-through inspection Software Version SR.50x.xx 01/2006 US Edition
230
5.3.2 Splicing the tape in good time
PLEASE NOTE:
Splice the tapes early enough so that the feeder modules do not run out of components. Oth-
erwise you will experience prolonged down times.
However, do not splice the tapes too early because if you wind the end of the old tape onto
the new reel after splicing, the reel holding the new tape may become overfilled and the tape
will slip off the reel and become tangled up. This will again result in pick-up errors and pro-
longed down times. 5
5.3.3 Checking the PCB supports
Æ
Check the position of the magnetic PCB supports on the lifting table:
– Make sure that the PCB supports do not collide with components on the underside of the
PCBs.
– In addition, make sure that the PCB supports do not collide with the PCB conveyor pan-
els.
5.3.4 Inserting separating plates in the tape container
Æ The separating plate has different edges and can be inserted into the tape container in two
ways. If spindles are used, the recesses for the spindles in the separating plate point upwards
(see item 6 in Fig. 5.3 - 2
). If you do not use spindles, the rounded edge of the separating plate
points up (see item 5 in Fig. 5.3 - 2
).
Æ Insert the separating plates as shown in Fig. 5.3 - 2 and remember that the smallest division
of the tape container is a 2x division. This will help avoid placement errors.
Æ Check that the separating plates engage in the same positions on the three guide rails. Oth-
erwise the separating plate will be offset or bent.
User manual SIPLACE HF series 5 Tasks on the machine
Software Version SR.50x.xx 01/2006 US Edition 5.3 Carrying out a walk-through inspection
231
5
Fig. 5.3 - 2 Separating plates in the tape container
(1) Guide rail for the separating plates
(2) Tape container
(3) Waste tape container
(4) Sliding surfaces for the tape reels
(5) Position of the separating plate if no spindles are used
(6) Position of the separating plate if spindles are used
5 Tasks on the machine User manual SIPLACE HF series
5.3 Carrying out a walk-through inspection Software Version SR.50x.xx 01/2006 US Edition
232
5.3.5 Using spindles for large tape reels
Æ Insert spindles into the separating plates when using large tape reels.
PLEASE NOTE
We recommend that you use spindles if the tape reel diameter exceeds 15" (381 mm)". This will
ensure that the feeder modules operate reliably.
5
Fig. 5.3 - 3 Inserting spindles for large reels
5
(1) Component trolley
(2) Position of the spindles
(3) Separating plate
(4) Spindle (enlarged)