00193631-0602.pdf - 第103页
Adjustment Instructions MTC 2 7 Entering the addresses of the masterdrives 12/2007 Edition 7.1 Masterdrives 103 Click the button "SA VE" Select "Online EEPROM" When the sett ings for the serial in…
7 Entering the addresses of the masterdrives Adjustment Instructions MTC 2
7.1 Masterdrives 12/2007 Edition
102
Create a new file based on factory settings, standardconfig.dnl (see picture above), this include
the parameter see picture below.
Choose the drive "Masterdrive MC Plus" and the software for MTC2 it is 1.6.
Note:
Software for the MTC 1 is 1.5!
Click the button "OK".
Adjustment Instructions MTC 2 7 Entering the addresses of the masterdrives
12/2007 Edition 7.1 Masterdrives
103
Click the button "SAVE"
Select "Online EEPROM"
When the settings for the serial interface correct you are connected directly with the drive now.
Caution:
All parameters which you change now will be send to the drive directly and they are immediately
active.
The serial interface could you check in the SW drive monitor under
"TOOLS" --> "ONLINE SETTINGS".
Upload Parameter set: (Storage the parameter set)
Choose "File" --> "UPLOAD" --> "BASIC DEVICE COMPLETE"
Save the parameter set under a name which make sense, for example feed axis tower 1 and
additionally the serial number of the MTC2.
7 Entering the addresses of the masterdrives Adjustment Instructions MTC 2
7.1 Masterdrives 12/2007 Edition
104
Fig. 1.1 - 7 Upload parameter set