00193631-0602.pdf - 第67页
Adjustment Instr uctions MTC 2 5 Feed axes 12/2007 Edition 5.2 Zero offset, removal position and tran sfer position 67 5.2.6 Calibrating the removal positions Check the zero of fset (see section 5.2.3 " Checking a…
5 Feed axes Adjustment Instructions MTC 2
5.2 Zero offset, removal position and transfer position 12/2007 Edition
66
5.2.5 Calibrating the zero offset
Carry out the relevant preparatory measures (see section 5.2.2 "Preparatory measures").
Carry out the steps according to section 5.2.3 "Checking and setting the zero offset".
Check the removal positions of the feed axis (see section 4.2.4 "Checking the removal positi-
ons").
Check the transfer position of the feed axis (see section 4.2.4 "Checking the transfer positi-
ons").
Check the end positions of the feed axis (see section 5.3.2 "Checking and calibrating the end
positions").
Adjustment Instructions MTC 2 5 Feed axes
12/2007 Edition 5.2 Zero offset, removal position and transfer position
67
5.2.6 Calibrating the removal positions
Check the zero offset (see section 5.2.3 "Checking and setting the zero offset").
Select the Settings button from the menu bar at the bottom.
Select "Tower 1" and "Feed axis".
Select "Teach removal position...".
5 Feed axes Adjustment Instructions MTC 2
5.2 Zero offset, removal position and transfer position 12/2007 Edition
68
Select "Cassette 2".
Confirm your choice by clicking on "OK".
Now calculate the maximum and minimum positions to engage the driver as follows (see
also section 5.2.3):
Move the feed axis to the position of the notch by arrows.
Select "Engage".
Either the notification "driver engaged successfully" or "driver could not engage".
the WTC without moving it.