YG300_Ope_E.pdf - 第49页

1-21 1 Part names and functions 3 A n o t h e r d i a l o g b o x a p p e a r s f o r c h e c k i n g m a n u a l c h a n g e n o z z l e s . 4 S p e c i f y t h e n o z z l e s y o u w a n t t o c l e a n b y n o z z l …

1-20

Part names and functions

9.1 Performing a nozzle shaft blow

This section explains how to manually perform a nozzle shaft blow at any desired timing.

Open the [Unit] – [Head] tab screen.

Press the [Cleaning Blow] button.

A confirmation dialog box appears asking whether to perform nozzle shaft blow.

Press the [OK] button to perform nozzle shaft blow and proceed to the next step. If you want to cancel

nozzle shaft blow, press the [Cancel] button.

Nozzle shaft blow

24100-M3-00

1-21

Part names and functions

Another dialog box appears for checking manual change nozzles.

Specify the nozzles you want to clean by nozzle shaft blow.

Pressing the [Close] button in the dialog box displays a screen for checking manual change nozzles as

shown below.

Dialog for checking manual change nozzles

Select the check boxes for the nozzles you want to clean by nozzle shaft blow.

24101-M3-00

1-22

Part names and functions

A confirmation dialog box appears asking you to make a final check.

Check the contents of the dialog box and press the corresponding button.

[Yes]: Performs nozzle shaft blow of the selected nozzles.

[No]: Returns to the previous dialog box.

[Cancel]: Closes the dialog box and returns to the [Unit]-[Head] screen without performing nozzle

shaft blow.

Final confirmation dialog box for nozzle shaft blow

24102-M3-00