YG300_Ope_E.pdf - 第82页
2-29 2 Basic operation 4 S e t t h e t a p e i n t h e t a p e f e e d e r . S e t t h e s e p a r a t e d l a y e r s o f t h e t a p e o n t h e t a p e f e e d e r t h r o u g h t h e t a p e p a t h s s h o w n i n t…
2-28
2
Basic operation
3.5 Preparing the component supply unit
3.5.1 Tape feeder
1. Checking the feed pitch and action
Press the manual feed lever to make sure that the tape is fed at a proper pitch.
Manual feed lever
Manual feed lever
23206-M0-00
2. Setting the tape
When fitting a new roll of tape to a tape feeder, set the tape with the procedure below. This section explains the
procedure using a CL type tape feeder as an example.
1
Peel off the top tape.
Tape consists of two layers: "carrier tape" that contains electronic components in the pockets and "top
tape" that covers the upper side of components on the carrier tape. Peel off the top tape to separate
these two layers.
2
Lift the clamping lever lock handle.
Lift the clamping lever lock handle to lift the tape guide.
3
Lift the tape guide.
Lift the tape guide while pressing the lock lever.
After the tape guide is lifted, return the lock lever to the original position and hold the tape guide in the
raised position.
Tape guide
Lock lever
Tape guide
Clamping lever lock handle
23217-M0-00
2-29
2
Basic operation
4
Set the tape in the tape feeder.
Set the separated layers of the tape on the tape feeder through the tape paths shown in the picture
below.
CL type tape feeder
: Top tape
: Carrier tape
A to E
E
A
a
a to c
c
C
B
b
D
8mm tape feeder
12mm, 16mm tape feeder
A
a
C
B
b
c
E
D
Tape path example
23208-M0-00
n
NOTE
Pass the top tape through the notch in the tape guide and turn it back.
Turning the top tape
Top tape
Notch
23209-M0-00
2-30
2
Basic operation
Press the idle roller assembly lever and insert the top tape between the drive roller assembly and the
idle roller assembly.
Drive roller assembly and idle roller assembly
Drive roller assembly
Idle roller assembly
23210-M0-00
5
Set the tape guide.
After the tape is set, press the lock lever to lower the tape guide.
Tape guide setup
Lock lever
Tape guide
23211-M0-00
n
NOTE
Set the carrier tape so that the tape feed gears fit into the feed holes in the carrier tape.