Process Lens PL Service Manual_EN.pdf - 第109页
3 Replacing spare parts Se rv ic e Ma nu al P ro ce ss L en s PL - 0 3/ 20 25 10 9 3.5.1.7 Boards Replacing the conveyor control TSP420 Parts Fig.147: Conveyor control TSP420 03087642-xx Conveyor control TSP420 complete…
3 Replacing spare parts
108 Service Manual Process Lens PL - 03/2025
Fig.146: Cables
The cables are run through the conveyor rails,
the hoses on the base(1) of the conveyor to the
conveyor control(2), the fiber optic cables are
run to the fiber optic sensors(3).
NOTICE!
Hoses
One hose (black or blue) always contains
all the cables / fiber optic cables for one
conveyor rail.
.
► Carefully unthread the cables / fiber optical
cables.
Remove any cable ties.
Installation
► Follow the removal instructions in reverse order for installation. Also observe the following
instructions:
CAUTION
Installation instructions
► Fiber optical cable: Check the settings for the transmitter / receiver and correct these if neces-
sary (see 3.5.1.6.4.1 "Setting the fiber optic sensor" [}101]).
► For an overview of the connectors, switches etc. of the TSP420, refer to section 3.5.1.7.1.1
"Conveyor control TSP420 [03087642-xx]" [}110].
► Replace any open cable ties.
Make sure that the cable ties and the heads of the cable ties do not rub against any parts when
you do this.
3 Replacing spare parts
Service Manual Process Lens PL - 03/2025 109
3.5.1.7 Boards
Replacing the conveyor control TSP420
Parts
Fig.147: Conveyor control TSP420
03087642-xx Conveyor control TSP420 complete
Equipment and tools
00096290-xx Fork wrench set
Side cutter
Cable tie
Removal
► Use the software or manually move the conveyor rail into a position which allows you best
access.
To move the conveyor side wall manually, pull the toothed belt of the width adjustment unit.
► Switch off the machine, disconnect it from the power supply and secure it to prevent unauthorized
reactivation.
► Move the gantry out of the transport area as far as possible to one side of the machine.
Fig.148: Covers
► Remove the spacer bolts fastening the
cover(1) above the conveyor control and
remove the cover.
► Unplug all electrical connections to the conveyor control. If necessary, mark their positions to
make clear assignment easier later on.
3 Replacing spare parts
110 Service Manual Process Lens PL - 03/2025
Fig.149: Spacer bolts
► Loosen the four spacer bolts(1).
► Remove the conveyor control together with the mounting plate from the machine.
CAUTION
Do not remove the conveyor control from the mounting plate.
The conveyor control may not be removed from the mounting plate because the mounting plate
serves as a cooling element for the conveyor control.
Installation
► Follow the removal instructions in reverse order for installation.
Conveyor control TSP420 [03087642-xx]
Two TSP420 are fitted in Process Lens.
The conveyor control "TSP420 assembly" [03087642-xx] comprises the following components:
●
Main board: TSP420-M [ 03087640-xx ]
●
I/O board: TSP420-IO [ 03087641-xx ]
CAUTION
These two boards may not be separated!