Process Lens PL Service Manual_EN.pdf - 第57页
3 Replacing spare parts Se rv ic e Ma nu al P ro ce ss L en s PL - 0 3/ 20 25 57 T1 Conveyor Track 1 T2 Conveyor Track 2 1 Input area 2 Inspection area 3 Output area 4 Lifting tables Lifting table 5 Conveyor drives Conve…
3 Replacing spare parts
56 Service Manual Process Lens PL - 03/2025
3.5 Replacing spare parts at the conveyor
DANGER
Observe User Manual
► Please observe the safety instructions in the user manual for all work!
CAUTION
Do not loosen or remove the wrong screws
The following applies to all work performed on the conveyor:
► Make sure that you do not loosen or remove any other screws except those ones explicitly men-
tioned. Loosening other screws could lead to irreparable misalignment or damage to the con-
veyor.
CAUTION
Moving the conveyor rails
► The fixed conveyor rail is fastened by screws, the moveable conveyor rail can be moved by
carefully pulling on the toothed belt of the width adjustment.
► After moving the conveyor rail manually, you may need to teach the conveyor rail position during
the conveyor reference run and recalibrate the light barriers.
3.5.1 Dual-lane conveyor
3.5.1.1 Conveyor - overview
Fig.69: Conveyor overview - part 1
3 Replacing spare parts
Service Manual Process Lens PL - 03/2025 57
T1 Conveyor Track 1
T2 Conveyor Track 2
1 Input area
2 Inspection area
3 Output area
4 Lifting tables
Lifting table
5 Conveyor drives
Conveyor drive
Fig.70: Conveyor overview - part 2
1 Width adjustment
Width Adjustment
2 Conveyor belts
Conveyor belt, belt drive and hexagonal shaft
3 Light barriers
Fiber Optic Cable and Light Barriers
4 Conveyor control TSP420
Boards
The flexible dual conveyor has two conveyor tracks that are electrically and mechanically independent
of one another.
By default, the fixed conveyor rails are in the "outer" position.
Optionally, the fixed conveyor rail can be selected - right/right or left/left.
Setting the fixed conveyor rail
The PCB dual conveyor can also be operated as a flexible single conveyor, no license is required for
Process Lens.
3 Replacing spare parts
58 Service Manual Process Lens PL - 03/2025
3.5.1.2 Lifting table
Replacing the lifting table plate
Parts
Fig.71: Lifting table plate
03114873‑xx Lifting table plate M-C
Equipment and tools
00376503-xx Torx L-Wrench Set with Spherical head (Torx 30)
Overview
Fig.72: Lifting table plate
1. Lifting table plate
2. Fastening screws (Torx30) for lifting table
plate
Removal
NOTICE
Does the lifting table stay in the top position?
If the lifting table remains in the top position and cannot be lowered, you will not be able to dismantle
the lifting table plate. In this case, call the SIPLACE Service team.
► Use the software or manually move the conveyor rail into a position which allows you best
access.
To move the conveyor side wall manually, pull the toothed belt of the width adjustment unit.
► Switch off the machine, disconnect it from the power supply and secure it to prevent unauthorized
reactivation.
► Move the gantry out of the transport area as far as possible to one side of the machine.