Process Lens PL Service Manual_EN.pdf - 第86页
3 Replacing spare parts 86 Se rv ic e Ma nu al P ro ce ss L en s PL - 0 3/ 20 25 Replacing the idler pulley (conveyor belt) Parts Fig.112: Idler pulley 03121201‑xx Idler pulley 20x2.5 M-C complete See also Replacing the…
3 Replacing spare parts
Service Manual Process Lens PL - 03/2025 85
Fig.111: Input side(1) and output side(2)
► Glue the sheet metal plate to the conveyor rail. Observe the following points:
●
On the input side(1), the side metal sheet plate is attached 1mm towards the inside.
●
On the output side(2), the side metal sheet plate protrudes the rail by 2mm.
► Fit the toothed belt.
Replacing the toothed belt (conveyor belt)
3 Replacing spare parts
86 Service Manual Process Lens PL - 03/2025
Replacing the idler pulley (conveyor belt)
Parts
Fig.112: Idler pulley
03121201‑xx Idler pulley 20x2.5 M-C complete
See also Replacing the pinion gear drive
Equipment and tools
00386253‑xx Torque screwdriver ESD 0.4 - 1.0Nm
03078706‑xx Bit holder for screwdriver TorqueVario
00326015‑xx Belt tension measuring device
00353832-xx Allen key set
Bit, size 4
If required:
Magnet lifter or tweezers and adhesive tape
Measuring scale
Removal
CAUTION
Toothed belt
► Make sure that the toothed belt is not folded or otherwise damaged.
► Use the software or manually move the conveyor rail into a position which allows you best
access.
To move the conveyor side wall manually, pull the toothed belt of the width adjustment unit.
Fig.113: Movable idler pulleys
► If you are replacing a movable idler pul-
ley(1), you will have to move the conveyor
rail to get access to the T-slot nut (see
below).
CAUTION!
Fix the T slot nut!
When replacing a movable idler pulley, fix
the T slot nut to the inner side of the con-
veyor rail (see description below).
.
► Switch off the machine, disconnect it from the power supply and secure it to prevent unauthorized
reactivation.
3 Replacing spare parts
Service Manual Process Lens PL - 03/2025 87
Fig.114: T slot nuts in conveyor rail
CAUTION
Replacing the movable idler pulley - fixing the T-slot nut
The movable idler pulleys are fixed to the inner side of the conveyor rail with a T slot nut [03113747-
xx].
If you want to remove a movable idler pulley, proceed as follows:
ü Before removing a movable idler pulley, first fix the T-slot nut.
► (1) When removing a movable idler pulley in the middle of the conveyor rail, you can reach the
T-slot nut through the hole on the other side of the conveyor rail. Use your finger or an appro-
priate tool to fix the T slot nut.
► (2) When removing a movable idler pulley at the beginning or the end of the conveyor rail, fix the
T slot nut with your finger (the conveyor rails are open at the side).
ð The T slot nut must not fall into the conveyor rail! The lack of room makes subsequent inser-
tion and fixture highly complicated if not impossible!
► Loosen the movable idler pulley.
CAUTION
Loosen the movable idler pulley only as far as necessary!
► Do not remove the movable idler pulley (unless you explicitly need to remove it). Otherwise the T
slot nut on the inner side will fall into the conveyor rail.
► Remove the idler pulley to be replaced.