Process Lens PL Service Manual_EN.pdf - 第116页
3 Replacing spare parts 11 6 Se rv ic e Ma nu al P ro ce ss L en s PL - 0 3/ 20 25 Fig.157: Sensor calibration ► Click on Sensor Calibration(4) to proceed the calibration of the PCB sensor. 3.5.2 Single-lane conveyor 3…
3 Replacing spare parts
Service Manual Process Lens PL - 03/2025 115
Fig.155: Confirming messages
► Click on Yes(5) to download the Bug Report first.
► Click on Yes(6) to download the Application BIOS.
3.5.1.8 Teaching the PCB sensors
Fig.156: “Unit function” tab and “System test” tab
► Click on this icon(1) to enter the settings menu.
► Click on Unit Function(2) to enter the settings user menu.
► Switch to operator level Machine service.
► Click on System Test(3) to enter the calibration menu.
3 Replacing spare parts
116 Service Manual Process Lens PL - 03/2025
Fig.157: Sensor calibration
► Click on Sensor Calibration(4) to proceed the calibration of the PCB sensor.
3.5.2 Single-lane conveyor
3.5.2.1 Changing the conveyor belt
Parts
03139303-xx Brecoflex timing belt 10T5/2440
Equipment and tools
●
Allen key size 2.0, 2.5, 4
●
Spanner size 10
Requirements
●
Machine is switched off.
●
Tension meter.
Removal
Fig.158: Gear and conveyor rod
► Remove the screw (1) to remove the rod
(3). Use a spanner size 10 and a short
Allen key size 4 to remove the screw (1).
► Move the rod (3) backwards.
3 Replacing spare parts
Service Manual Process Lens PL - 03/2025 117
Fig.159: Clamping plate
► Remove the clamping plate off the con-
veyer system by unscrewing the screws
(2) using an Allen key size 2.0.
WARNING!
Springs inside the clamps (1)
.
The clamps (1) of the conveyer system bear
springs.
Make sure all parts are retained.
Fig.160: Tension ring of the conveyor unit
► Loose the tension ring (1) of the belt (3) to
release the tension of the belt. Unscrew
the screw (2) by using an Allen key size
2.5.
Fig.161: Gear
► Remove the gear (2).
► Change one screw (1) using an Allen Key
size 4.0 and 2 screws (1) using an Allen
key size 2.5.
► Remove the belt and replace it with a new
one.
► Put back the gear by tighten the screws
(3x).
► Put back the clamping plate by tighten the
screws (6x).
► Put back the tension ring and fasten the
belt by tighten the screw (1x).