DECAN_S2_Admin(Eng_Ver4.5).pdf - 第512页

15-61 System Setup Sets the threshold of the vi s ion system used to recogni zed the degree of nozzle tip contamination.  <Light Level / Light Adjust> slide bar Sets the lightin g of the fly camera.  <Mirr or …

15-60

Advanced Chip Shooter DECAN S2 Administrator’s Guide

15.5.5. <Nozzle> tab dialog

Sets the parameter of the fly camera when checking for the contamination of a nozzle tip.

Figure15.21 “Nozzle” Tap dialog

 <Inspection Type> combo box

Sets the parameter of the fly camera when checking for the contamination of a nozzle

tip.

 Dirty Check

The parameters of the fly camera used to test whether the nozzle tip is polluted are

displayed on the screen.

 Tip Check

The parameters of the fly camera used to test whether the nozzle tip is present are

displayed on the screen.

 Holder Check

The parameters of the fly camera used to test the nozzle holder are displayed on

the screen.

 <Position> group

 Z-Pos

Indicates the Z-axis height from the upper surface of the PCB to the nozzle tip

end.

 M-Pos

Indicates the rotation angle of the mirror for the fly camera.

 <Threshold> column

15-61

System Setup

Sets the threshold of the vision system used to recognized the degree of nozzle tip

contamination.

 <Light Level / Light Adjust> slide bar

Sets the lighting of the fly camera.

 <Mirror Open / Mirror Close> button

Opens or closes the mirror installed on the head module. Closing the mirror will allow

a user to check the nozzle tip with a vision system.

 <Binary / Real> button

Shows the image seen through the Vision in real display to which threshold is not

applied, or in the image (Binary) to which threshold is applied as recognized by MMI.

15-62

Advanced Chip Shooter DECAN S2 Administrator’s Guide

15.6. Device [F11]

Controls the data related to the tape, stick and tray and nozzle.

15.6.1. Tape Feeder

The following screen shows that the ‘Tape’ is selected from the list box. Set the parameters

for the tape feeder.

Figure15.22 “Standard Device - Tape” dialog box

 List box

Select the tape feeder type to be set up.

 <Timing> group

 <Open Time> edit box

Time needed to feed the tape feeder.

 <Feeding Time> edit box

Time needed to feed the tape feeder.

 <Normal Feeding Time> edit box

Sets the time it takes generally for the tape feeder to feed the part once.

 <Real Transfer Time> edit box

Sets the time required to transfer the reel in order to supply parts from the tape

feeder.

 <Pickup Offset> edit box

Set the X offset value of the pick-up position of the tape feeder.Based on the setting of

the tape feeder in the front of the equipment, set the offset value of the pick-up