OM-1012-001.pdf - 第107页
5.2 Program Change Tg0869-PM-OM (4) Put the knob of the magazine stopper between fingers as shown in Fig. A56 and turn it clockwise by approx. 90 ° ‹while pulling it forward. (See Arrows *1 and *2 in Fig. A55.) Pulling F…
5.2 Program Change
Tg0869-PM-OM
5.2.3 Attachment and Detachment of Magazine
5.2.3.1 Attachment of Magazine
Described below is how to attach the magazine to the internal sections of the
elevator for the first time after a multi-layer tray feeder is installed.
(1) Perform the zeroing operation.
Refer to “2. Zeroing Operation of Section 4 in Chapter 1” and “11.1.2
Zeroing Operation Maneuvered on Main Machine Side of Section 2 in
Chapter 1” for details.
(2) Press the [U READY] or the [L READY] button on the magazine loaded
side.
The LED of the pressed button extinguishes.
While the LED of the [U READY] or the [L READY] button is
“ON”, the door (the upper or the lower door) cannot be opened.
(3) Hold the grip of the door whose button is pressed in Step (2) and pull it
forward to open the door.
0305-001 Chapter 1 2-27
[U READY] Button
Upper
Door
Grip
[L READY] Button
Magazine Base
Lower
Door
Grip
Magazine Base
Fig. A53 Rough View (FP-5022L) Fig. A54 Rough View (FP-5022R)
5.2 Program Change
Tg0869-PM-OM
(4) Put the knob of the magazine stopper between fingers as
shown in Fig. A56 and turn it clockwise by approx. 90°
‹while pulling it forward.
(See Arrows *1 and *2 in Fig. A55.)
Pulling Force of Magazine Stopper
39.2 N to 49.0 N (4 to 5 kgf)
Fig. A55
Fig. A57 Grips of Magazine “MG-5050L” (Same to “MG-5050R”)
(5) Hold the handle of the magazine base and pull it forward until it stops.
Locking Pin
Block
Fig. A56 Magazine Base
Knob Handle
Approx. 90°
Magazine Stopper
0305-001 Chapter 1 2-28
Grip of Magazine
Grip of Magazine
5.2 Program Change
Tg0869-PM-OM
(6) Hold the magazine handle (Refer to Fig. A57) and set the magazine care-
fully on the magazine mounting section: then press the magazine against
the rear stopper.
Confirm that the magazine is set in place along the side and rear stoppers
and is not tilted.
Fig. A59 The status before folding the grip of the magazine.
“MG-5050L” (Same to “MG-5050R”)
Fig. A58 Magazine Base (Slid Out)
There are two types of magazines - “MG-5050L” for “FP-5022L”
and “MG-5050R” for “FP-5022R”. Do not make a mistake of
wrong selection. Otherwise, an error will occur.
(7) Fold down (close) the grips of the magazine.
When the magazine is pushed inward with the grips kept open,
the grips will be caught by the multi-layer tray feeder, blocking
the way to the rear end.
0305-001 Chapter 1 2-29
Side Stopper Side Stopper
Rear Stopper