OM-1012-001.pdf - 第98页
5.2 Program Change Tg0869-PM-OM 0305-001 Chapter 1 2-19 5.2.2 Preparation of Magazine 5.2.2.1 Precautions in Magazine Handling • Do not pile up magazines removed from the unit. Do not put anything on the upper surface of…
5.2 Program Change
Tg0869-PM-OM
(5) Pull out the pins, etc., which were inserted in Step (3).
The tray is suppressed in the Y direction.
5.2.1.3 Tray Detachment from Pallet
(1) Push the lever of the tray fixing metal and hold it at the position where
the roller of the metal has separated from the tray.
(2) Detach the tray from the pallet.
View A View B
Fig. A32 Location of Fixing Metals for TL (Same for TR)
0305-001 Chapter 1 2-18
5.2 Program Change
Tg0869-PM-OM0305-001 Chapter 1 2-19
5.2.2 Preparation of Magazine
5.2.2.1 Precautions in Magazine Handling
• Do not pile up magazines removed from the unit. Do not put anything
on the upper surface of the magazine. If the magazine is deformed it
can cause such abnormality as machine breakdown when the magazine
is set on the tray feeder.
• When the magazine is put on the desk or floor, ensure there is no dust
or foreign substance on the magazine’s base. If the magazine is placed
as shown in Fig. A33 and set in the unit with dust or other foreign
substance on the magazine base it can cause breakdown, because the
machine is operated with the magazine inclined.
Fig. A33
Fig. A34
5.2 Program Change
Tg0869-PM-OM
• Do not exchange the upper magazine with the lower magazine or be-
tween the units. It can cause breakdown.
Fig. A35
0305-001 Chapter 1 2-20
• When the magazine door is opened on the tool bench place a board
about 10 mm thick under the magazine so that the magazine door opens
horizontally, then open the magazine door. If the magazine door is
opened without placing such a board, the door can't be opened horizon-
tally.
Fig. A36