CP-842E-842ME System Reference-SYS-CP842-10E.pdf - 第125页

Machine System >> Panel ID Read Function ( Option) SYS-CP842-1.0E 4-89 Fujitrax-Profiler Set tings Perform the same setting procedures fo r code reading by the mark camera. Barcode Reader Adjustment The barcode rea…

100%1 / 220
Machine System >> Panel ID Read Function (Option)
4-88
SYS-CP842-1.0E
The communication port to be used for the panel ID reader connection can be specified
at the [Barcode Management] screen. ID reading tests can also be performed here.
1 A green indicator appears over the [Use Upper ID Reader] button when on (upper ID
reader “Used”).
2 Depressed when “Used” setting is specified.
3 Sets the Upper ID Reader’s connection port No. Press to display a ten-key pad, then
enter the port No. to which the Upper ID Reader is to be connected. Use care to avoid
entering a vacant port No. or a port No. in use by another device. This port No. setting
is a factory setting, and does not normally require changing.
4 “Port No.” display area.
5 On/off indicator for the [Use Lower ID Reader] button.
6 Depressed when “Used” setting is specified.
7 Sets the Lower ID Reader’s connection port No. Press to display a ten-key pad, then
enter the port No. to which the Lower ID Reader is to be connected. Use care to avoid
entering a vacant port No. or a port No. in use by another device. This port No. setting
a factory setting, and does not normally require changing.
8 “Port No.” display area.
43
1
2
5
6
78
C73OM0045
Machine System >> Panel ID Read Function (Option)
SYS-CP842-1.0E 4-89
Fujitrax-Profiler Settings
Perform the same setting procedures for code reading by the mark camera.
Barcode Reader Adjustment
The barcode reader position must be adjusted to accommodate a production panel
change, or changes in the panel ID barcode position. In such cases, adjust the reader
to a position where normal reading can occur.
Adjust the following as necessary:
• Position (Y-direction), Height (33 mm 5 mm)
• Barcode reader tilt
(A tilt of 10~40 degrees, 15~40 degrees is required. See the illustration below.)
• Barcode reader orientation (parallel or perpendicular to conveyance direction).
View from above in-conveyor
View of in-conveyor from left side of machine
Barcode reader
orientation adjustment
Position adjustment
Barcode reader
Trigger sensor
In-conveyor
In-conveyor
Production panel
Barcodes
Barcode reader
Tilt adjustment
(15 ~ 40 deg.)
Tit adjustment
(10 ~ 40 deg.)
Height adjust
(33 mm ± 5 mm)
Machine System >> Panel ID Read Function (Option)
4-90
SYS-CP842-1.0E
n Barcode Reading Test
After adjusting the barcode reader to its approximate position, open the [Barcode
Management] screen and perform a test reading of the panel ID barcode, and fine-
adjust the barcode reader position until the barcode is being read properly.
Place a panel on the conveyor, then press [Test Start or End]. Fine-adjust the reader
position until the reading success rate is high (approx. 100%).
9 Selects the reader (upper or lower) to be used for reading test
10 Indicates the reader (upper or lower) being used for reading test.
11 Switches the test mode being used for reading test.
12 Indicates the current test mode being used for reading test.
13 Starts and stops the test.
14 Display area for reading success rate / success count.
15 Display area for content of barcode which was read.
9
10
11
12
13
14
15
%1/