4OM-1429-008_w.pdf - 第84页
1-25 3.3 Inspection, Cleaning, and Lubrication Spots Notice Be sure to use a suction force such as a vacuum cleaner for the cleaning. Do not blow air to any cleaning section with an air gun. When air is blown, th e dirt …
1-24
CAUTION
Before removing the accumulated components from the box, be
sure to connect a grounding cable (used to make a connection to
ground) to your body.
Otherwise, some component may be damaged by static electricity.
Hanenaito (Vibration Proof Rubber)
Every Day Cleaning
Required Time: 1 minute
Take out Hanenaito from the component
storage box and clean it with a vacuum
cleaner.
Component Storage Box
Every Day Cleaning
Required Time: 1 minute
Remove components collected in the box.
Fig. 4A15
3.3 Inspection, Cleaning, and Lubrication Spots
0707-001
1-25
3.3 Inspection, Cleaning, and Lubrication Spots
Notice
Be sure to use a suction force such as a vacuum cleaner for the
cleaning.
Do not blow air to any cleaning section with an air gun.
When air is blown, the dirt and dust inside the machine will disperse,
causing the recognition system and the machine to malfunction.
QFP Glass Plate Jigs (2 pcs.)
Every Month Cleaning
Required Time: 1 minute
Wipe the jigs with a dry lens cleaning cloth.
Sebum (fingerprint) or oil
should not adhere to the QFP
glass plate jigs.
If sebum or oil adheres, wipe it
off with a lens cleaning cloth
which contains a small amount
of alcohol.
Teaching Plates (4 places)
Every Month Cleaning
Required Time: 1 minute
Remove foreign substances and unrequired
components and wipe off dirt and dust with
a rag.
Fiducial Marks (4 places)
Every Week Cleaning
Required Time: 2 minutes
Wipe the upper surfaces of the fiducial
marks with a dry lens cleaning cloth.
Sebum (fingerprint) or oil
should not adhere to the
fiducial marks.
If sebum or oil adheres, wipe it
off with a lens cleaning cloth
which contains a small amount
of alcohol.
Notice
Notice
Fig. 4A16
0707-001
1-26
3.3 Inspection, Cleaning, and Lubrication Spots
3.3.4 Feeder Base Driving Section
Worm Gears
(2 places)
Every 3 Months Lubrication
(MOLYNOC GREASE AP1)
Required Time: 2 minutes
Apply a small amount of new grease to the
worm gears with a syringe.
Use No. 19 (brown) nozzle.
Note
No. 19 (brown)
Fig. 4A16-1
0707-001