4OM-1429-008_w.pdf - 第96页
1-36 3.3.8 X/Y Beam Section CAUTION Y our hand might be cut at the edge of the linear guide in the cleaning operation. Wear gloves. X-Axis Linear Guides (4 places) Every 3 Months Cleaning and Lubrication (DAPHNE EPONEX G…
1-35
CAUTION
When the air-blowing is to be performed to the nozzle, make sure
to start it from the nozzle end section.
If the air-blowing is started from the clamp claw section, the clamp
claw might be damaged.
Vacuum Nozzle
Every 3 Months Inspection
Check the condition of the vacuum nozzle. When
the nozzle end is worn out, replace it with a new
one.
Vacuum Nozzle
Every Week Cleaning
• Clean the tapered area of the nozzle with a lens
cleaning cloth.
• Store the nozzle in the nozzle stocker (housing)
through window navigations and take out the
nozzle stocker (housing). After that, blow air to
the stocker (housing) to remove dirt and dust.
(a) Do not take out a nozzle from the
head by hand. Otherwise, the
nozzle does not conform to the
nozzle data.
(b) When the nozzle is extremely dirty
or the vacuum suction force
weakens, causing the nozzle to
improperly pick or place components,
it is required to clean the nozzle in the
water with an ultrasonic cleaner.
Do not use anything other than water
for the cleaning.
(a) Refer to "4.1 Cleaning of Vacuum
Nozzles" for details.
(b) Refer to "6. "Nozzle Change" Window"
in "Chapter 3 (Vol. 2)" for the procedure
of nozzle storage.
Notice
Reference
Clamp Claw
Air Blowing from the Tip
Fig. 4A23
3.3 Inspection, Cleaning, and Lubrication Spots
0808-002
1-36
3.3.8 X/Y Beam Section
CAUTION
Your hand might be cut at the edge of the linear guide in the
cleaning operation. Wear gloves.
X-Axis Linear Guides (4 places)
Every 3 Months Cleaning and Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 5 minutes
Wipe off old grease with a rag and supply
new grease to the grease nipples with a
hand grease gun.
Take ample care not to leave
any waste threads after
cleaning.
Grease should be applied every 3 months
after the initial month.
X-Axis Linear Guides (2 places)
Every Day Inspection
Required Time: 1 minute
Check visually for any dropped foreign
substance, etc.
Notice
Fig. 4A24
3.3 Inspection, Cleaning, and Lubrication Spots
0712-002
1-37
CAUTION
Your hand might be cut at the edge of the linear guide in the
cleaning operation. Wear gloves.
Y-Axis Linear Guides (8 places)
Every 3 Months Cleaning and Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 5 minutes
Wipe off old grease with a rag and supply
new grease to the grease nipples with a hand
grease gun.
Take ample care not to leave
any waste threads after
cleaning.
Grease should be applied every 3 months
after the initial month.
Y-Axis Linear Guides (2 places)
Every Day Inspection
Required Time: 1 minute
Check visually for any dropped foreign
substance, etc.
Notice
Fig. 4A25
3.3 Inspection, Cleaning, and Lubrication Spots
0712-002