4OM-1429-008_w.pdf - 第87页
1-28 Scrap Inspection Hole Scrap Box Every Day Cleaning Required T ime : 1 minute When the scrap box seen from the scrap inspection hole, is filled with empty tapes, draw out the scrap box and remove the empty tapes. Fig…
1-27
3.3.5 Feeder Cart Section
Groove on Feeder Base
Every Week Cleaning
Required Time:
2 minutes
Suck dirt and dust with a vacuum cleaner.
Upper Surface of Feeder Base
Every Day Cleaning
Required
Time: 2 minutes
Remove foreign substances and unrequired
components
wit
h a vacuum cleaner and
wipe off dirt and dust
with a rag.
Fig. 4A17
3.3 Inspection, Cleaning, and Lubrication Spots
0707-001
1-28
Scrap Inspection Hole
Scrap Box
Every Day Cleaning
Required Time
: 1 minute
When the scrap box seen from the scrap
inspection hole, is filled with empty
tapes, draw out the scrap box and remove
the empty tapes.
Fig. 4A18
Upper Surface of Suppressor
Every Day Cleaning
Required Time: 2 minutes
Remove dirt and dust with a vacuum
cleaner and wipe the surface clean with a
rag.
Fig. 4A18-1
3.3 Inspection, Cleaning, and Lubrication Spots
0707-001
1-29
3.3.6 Cutter Section
Transparent Cover
(Motor Side)
Transparent Cover
(Origin Side)
Cutter Boxes (Both Sides)
Every Week Cleaning
(1) Detach the bank feeder change cart.
(2) Move the cutter unit with the [Move Maint. Pos.]
button in the "CUTTER ADJ" window
(the window that opens after the [CUT ADJ]
b
utton on the "UNIT ADJ" submenu bar is pressed).
(3) Turn off the power supply.
(4) Open the cover.
(5) Detach the transparent covers located on both
sides (origin and motor sides) of the cutter sectio
n
and remove dirt and dust with a vacuum cleaner.
Use a vacuum cleaner with a narrow air opening
in the nozzle.
Note
Narrow Air Opening in Nozzle End
(Recommended)
Required Time: 2 minutes
Fig. 4A19-1
3.3 Inspection, Cleaning, and Lubrication Spots
0707-001