4OM-1429-008_w.pdf - 第88页
1-29 3.3.6 Cutter Section T ransparent Cover (Motor Side) T ransparent Cover (Origin Side) Cutter Boxes (Both Sides) Every W eek Cleaning (1) Detach the bank feeder change cart. (2) Move the cutter unit with the [Move Ma…
1-28
Scrap Inspection Hole
Scrap Box
Every Day Cleaning
Required Time
: 1 minute
When the scrap box seen from the scrap
inspection hole, is filled with empty
tapes, draw out the scrap box and remove
the empty tapes.
Fig. 4A18
Upper Surface of Suppressor
Every Day Cleaning
Required Time: 2 minutes
Remove dirt and dust with a vacuum
cleaner and wipe the surface clean with a
rag.
Fig. 4A18-1
3.3 Inspection, Cleaning, and Lubrication Spots
0707-001
1-29
3.3.6 Cutter Section
Transparent Cover
(Motor Side)
Transparent Cover
(Origin Side)
Cutter Boxes (Both Sides)
Every Week Cleaning
(1) Detach the bank feeder change cart.
(2) Move the cutter unit with the [Move Maint. Pos.]
button in the "CUTTER ADJ" window
(the window that opens after the [CUT ADJ]
b
utton on the "UNIT ADJ" submenu bar is pressed).
(3) Turn off the power supply.
(4) Open the cover.
(5) Detach the transparent covers located on both
sides (origin and motor sides) of the cutter sectio
n
and remove dirt and dust with a vacuum cleaner.
Use a vacuum cleaner with a narrow air opening
in the nozzle.
Note
Narrow Air Opening in Nozzle End
(Recommended)
Required Time: 2 minutes
Fig. 4A19-1
3.3 Inspection, Cleaning, and Lubrication Spots
0707-001
1-30
3.3 Inspection, Cleaning, and Lubrication Spots
WARNING
Pay close attention to the cutter blade during the maintenance work.
•
Lack of attention will result in a hand injury, etc.
Wear gloves and take the greatest care in performing the work.
•
Be sure to attach the fixing jig to the cut unit during the
maintenance work for safety purposes.
Upper Cover
Lower Cover
Linear Guides
Every 3 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 10 minutes
(1) Remove four screws and detach the tape guide.
(2) Wipe old grease out using a rag and apply new
grease onto the linear guide (upper and lower
sides).
Tape Guide
When the tape guide is
detached or attached,
be sure to keep the Y-axis
linear scale free of nicks
and scratches.
Notice
Cutter Box
Every 3 Months Cleaning
Required Time: 5 minutes
(1) Remove four screws and detach
the tape guide.
(2) Use the outer hole of the cut unit
fixing jig and attach the jig with
the bent portion being directed
downward.
Attachment Position of
Cut Unit Fixing Jig
(3) Clean the area around the linear
guides with a vacuum cleaner.
Use Type N nozzle.
Type N
Refer to "4.5 Lubricating Procedure onto the
Linear Guide Oil Filler Port" for lubricating
procedure.
Note
Reference
Fig. 4A19-2
0712-002