Vermes MDS 358X user Manual.pdf - 第6页
Rem oving Air Inclus ions from the F luid Box Para mete r Inpu t and Start Disp ensin g and Pos itioni ng of Dots (Mod es) Oper ation Trigg ering a D ispen se Se quen ce Fig. 4 8: Sy stem beha vior Para mete rs for the D…
Connecting a Heater
Fig. 27: Connector sensor cable - grip
Fig. 28: Switching Power Supply 48 V 4 A Push-Pull and its connector
Power Supply
Connecting a Cooler
Fig. 29: Heater MDH-48-BY
Fig. 30: Heater cable 48 V
Fig. 31: Flow Control Valve FCV-AC 6.0 M12
Connection Diagram
Fig. 32: Connection Cable for FCV-AC/HF M12 to MDC
Fig. 33: Connection diagram of MDS 358X
Fig. 34: Valve with air cooling connected
Valves with Air cooling
Fig. 35: Screwing tight the nozzle fixation nut
The Adjust Process
Fig. 36: Adjust - Press [ADJ]
Fig. 37: Message Adjust Screw OUT
Fig. 38: Screw open adjust screw
Fig. 39: Adjust - Press [ENTER]
Fig. 40: Message 500 Shots - Please Wait
Fig. 41: Message Please wait
Fig. 42: Message Adjust Screw IN - until green LED
Fig. 43: Message Screw further IN
Fig. 44: Arrows displayed
Fig. 45: Message press enter! - 0, the green adjust LED is ON
Fig. 46: Adjust - Press Enter
Fig. 47: Message Adjust Screw OUT - X <<<<, the red adjust LED is
ON
Initial Liquid Supply
Removing Air Inclusions from the Fluid Box
Parameter Input and Start
Dispensing and Positioning of Dots (Modes)
Operation
Triggering a Dispense Sequence
Fig. 48: System behavior
Parameters for the Dispensing Process
Tab. 20: Parameters for dispensing
Minimum and Maximum Parameter Limits
Tab. 21: Minimum and maximum parameter limits
Input of Values
Retrieving Parameter Sets
Saving Parameter Sets
Fig. 50: Schematic of usage of select pins, example
Select Pins
Fig. 51: Circuit diagram
Tab. 22: Select Pin settings for the setups
Basics about Scenarios
Fig. 52: Scenarios of an MDC
Scenarios
Entering Scenarios
Scenario Selection with Select Pins
Fig. 49: Select Pins
Fig. 53: Select Pins
Fig. 54: Schematic of usage of select pins
Tab. 23: Select Pin settings
Factory Settings
Tab. 24: Factory settings of the setups
Tab. 25: Factory settings of the scenarios
Auxiliary Mode
Adjust Offset
Fig. 55: Submenu Service-Option
Dispensing with a Heater
Fig. 56: MDH-48-BY
Calibration of the Heater
Fig. 57: Submenu Heater
Fig. 58: Calibrator Set
Heater and MDC
Tab. 26: Calibration of the heater
Cooling and MDC
Dispensing with a Cooling Valve
Fig. 59: FCV-AC 6.0 M12
Cooler Offset
Fig. 60: Submenu Cooler
Switching OFF the Microdispensing System
Communication Interfaces
Fig. 61: Serial interface
Pin Functions
Serial Interface RS-232C: 9-Pin Sub-D
RS-232C Commands
Overview
Explanations
Fig. 62: PLC Interface: 15-pin, Sub-D
PLC Interface: 15-pin, Sub-D
Pin Functions
Burst Mode (Example with Three Shots)
Fig. 63: Single-Shot Mode
Fig. 64: Burst Mode (Example with Three Shots)