SME_Jig_User_Guide(Eng_Ver1).pdf - 第75页
4-17 Program Installation Caution Turning off the power supply t o the tape feeder while upgrading the tape feeder f irmware will cause serious damage to the tape feeder main board. Do not turn off the power supply to t …
4-16
User's Guide For Tape Feeder Calibration Jig
6. Click the <F/W Download> button to upgrade the firmware.
Memo
According to the firmware upgrade progress, the status of the tape
feeder is displayed as follows:
w When the firmware version of the tape feeder is 2.xx
Flash Erase: The tape feeder status LED is displayed in white.
Flash Program: The tape feeder status LED blinks in white.
Flash Verify: The tape feeder status LED is displayed in white.
w When the firmware version of the tape feeder is 1.xx
Flash Erase: The tape feeder status LED is displayed in blue.
Flash Program: The tape feeder status LED blinks in blue.
Flash Verify: The tape feeder status LED is displayed in blue.
7. Finish tape feeder firmware upgrade. Then after checking whether the entire program
status display area has turned green, remove the tape feeder from the feeder base.
4-17
Program Installation
Caution
Turning off the power supply to the tape feeder while
upgrading the tape feeder firmware will cause serious
damage to the tape feeder main board.
Do not turn off the power supply to the tape feeder while
upgrading the firmware. Otherwise, we are not responsible
for the damage to the main board considering that the main
board was damaged due to user's carelessness.
When a problem occurs, contact our C/S.