SME_Jig_User_Guide(Eng_Ver1).pdf - 第77页
5-1 Maintenance Chapter5. Maintenance 5.1. Calibration Jig Maintena nce and Maintenance Items Table5.1 Periodical Insp ection Table5.2 Consumables Repl acement Cy cle Item Description Inspection interval Calibration Jig …
5-1
Maintenance
Chapter5. Maintenance
5.1. Calibration Jig Maintenance and Maintenance Items
Table5.1 Periodical Inspection
Table5.2 Consumables Replacement Cycle
Item Description
Inspection
interval
Calibration Jig Remove of foreign materials on the feeder base
/ vertical plate.
Daily
Apply rust preventive oil to the feeder base /
vertical plate
6 months
Tape Feeder Inspect tape feeders Annually
Lifetime management and overhaul Feeding
count: 40
million
Master Feeder Check the origin of the master feeder. Annually
Item Replacement Cycle
Master Tape After using 150 times (Refer to "5.5. Master Tape Usage
Management")
Feeder Base
Board
After installing/removing feeders in/from the feeder base slots
10,000 times (Refer to "5.6. Feeder Base Board
Replacement")
5-2
User's Guide For Tape Feeder Calibration Jig
5.2. Calibration Jig
5.2.1. Cautions Regarding Calibration Jig Maintenance
When disassembling the jig cover randomly, internal components may be damaged duo to
incoming microchips or foreign materials and external impact. Use the calibration jig or
perform maintenance with the jig cover being assembled.
Memo
When replacing the service parts, remove the jig cover.
Caution
Do not use the calibration jig with the cover of the area
indicated in the following figure being removed: