SME_Jig_User_Guide(Eng_Ver1).pdf - 第83页
5-7 Maintenance Caution Fixing the set screw b y applying excessive force may damage the screw.
5-6
User's Guide For Tape Feeder Calibration Jig
Caution
When adjusting the X eccentric pin, insert the shortest part
of the 2.5 mm hex wrench into the hexagonal hole.
Incorrect insertion of the 2.5 mm hex wrench into the hex
hole of the X eccentric pin may damage the hex hole of the
X eccentric pin.
4. In the vision window, adjust the X eccentric pin so that the spacing between the master
tape hole center and the green crosshair center will be less than ±1 cell.
5. After removing the 2.5 mm hex wrench used for the adjustment of the X eccentric pin,
insert a 1.5 mm hex wrench into the set screw and turn it clockwise to fix the set screw.
5-7
Maintenance
Caution
Fixing the set screw by applying excessive force may
damage the screw.
5-8
User's Guide For Tape Feeder Calibration Jig
5.4. Master Feeder
In the case of a master feeder, the reliability of the origin must be maintained by
performing calibration regularly. If defects such as distortion of part supply position, etc.,
occur due to failure of regular calibration of the master feeder, our company is not
responsible for this problem.
Caution
w Contact our designated C/S company (STS) or local agent once a
year and calibrate the master feeder.
w When sending the master feeder to our designated C/S company
(STS) or local agent, put it in the dedicated storage box and send
it.
w When the master feeder is dropped or damaged, immediately
calibrate it.