3_AVS-V2_MCT-UM-internal_EN_07-2019.pdf - 第106页

ASM AVS - U SER M ANUAL P AGE 106 OF 182 • If no USC is present, r efer to the settings in the foll owing table. Parameter Recommended Settin g Parameter Recommended Settin g FRONT PRINT SP EED 25mms -1 CHASE CLAMP PRE S…

100%1 / 182
ASM AVS - USER MANUAL
PAGE 105 OF 182
In addition to the above the Printing machine should have the following settings:
• Maintenance / Machine Setup / Transport Mode – Left to Left
• Maintenance / Machine Setup/ Screen Size - ensure set correctly (typically 249)
• Maintenance / Machine Setup / Basics /Upline and Downline – Manual
• Chase Clamp pressure set to 0.35MPa (3,5 bar) – this should be adjusted on the regulator at
the back left of machine.
• Ensure that sufficient cleaning material is available on the role.
For the MCT 1m is needed.
• If a blue USC is used, then set it to "Dry / Dry every board".
• Ensure when using a Cyclone cleaner that "Dry / Dry with Oscillate" is set.
ASM AVS - USER MANUAL
PAGE 106 OF 182
• If no USC is present, refer to the settings in the following table.
Parameter
Recommended Setting
Parameter
Recommended Setting
FRONT PRINT SPEED
25mms
-1
CHASE CLAMP PRESSURE
3 - 4 bar (nominal 3.5 bar)
REAR PRINT SPEED
25mms
-1
CLEAN REGIME
Double Dry Oscillate
PRINT FRONT LIMIT
40.0000 mm
CLEAN SPEED
Default
PRINT REAR LIMIT
40.0000 mm
STENCIL
FG Stainless 100µm
FRONT PRINT FORCE
39.24N (4.00 kg setting)
STENCIL FRAME
HTVG
FRONT PRINT FORCE
39.24N (4.00 kg setting)
PRINT MEDIA
Loctite 3616
SNUG FORCE
40N
SQA Width
250mm
BOARD CLAMP PRESSURE
3 bar
SQA Overhang
25mm
PRINT GAP
0.00mm
SQA Material
Stainless
SEPARATION SPEED
1.0000 mm/s
SQA Angle
60 degree
SEPARATION DISTANCE
3.0000 mm
Apply the glue
Insert the Stencil with the label (serial no., barcode) in the left front corner.
Ensure the glue has been removed from the fridge at least 8 hours before the test, and allowed to
warm up to ambient temperature.
A bead of glue (print material) can now be added to the front of the image, this can be positioned
just in front of the first row of apertures and be around 15mm in diameter (see picture below).
Ensure the print direction is Front to Back.
NOTICE
Stencil and Glue recommendation
We recommend a Stencil with either 800µm circles or with 1mm Squares.
For the Paste material we recommend a Glue LOCTITE 3616 red, which can be purchased in a 400ml
cartridge, which can be clamped into a silicone-filled syringe from the hardware store.
ASM AVS - USER MANUAL
PAGE 107 OF 182
Test Procedure Flowchart