4OM-1003-007.pdf - 第108页

(25) Control Box Section 1.3 Maintenance Spots 0305-001 1-45 AIL01ETRP Front Cover B Setscrews Front View of Machine Front Cover A Filter 1M40 Every Month Cleaning Clean the filter of the control box with a vacuum cleane…

1.3 Maintenance Spots

0511-002 1-44 AIL01ETRP

Lower Section of Linear Guide 3M28

Every 3 Months Lubrication (DAPHNE EPONEX GREASE No. 3)

Follow the steps below for the lubrication.

1. Close the air valve and allow the air to bleed out of the machine.

2. Rotate the rotary turret with the hand-rotating wheel to move the

linear guide to be lubricated between Stations #5 and #6

(Turret Angle: 108 degrees).

3. Set the dispense gun to "1".

4. Insert the nozzle to be used into the oil inlet and inject grease slowly,

spending about 10 seconds.

Note: Inject grease (quantity: 0.06 to 0.1 g) only once.

* Use the HL2-type nozzle.

Grease should be applied every 3 months after the initial month.

Oil Inlets

Fig. 4A49

(25) Control Box Section

1.3 Maintenance Spots

0305-001 1-45 AIL01ETRP

Front Cover B

Setscrews

Front View of Machine

Front Cover A

Filter 1M40

Every Month Cleaning

Clean the filter of the control box with a vacuum cleaner.

Fig. 4A50

(26) Filters and Cooling Fans in Each Section

1.3 Maintenance Spots

0407-002 1-46 AIL01ETRP

Fans on Top of Machine 3M30

Every 3 Months Cleaning

Remove the filters from the cooling fans on the top

of the main body and clean them with a vacuum

cleaner.

After cleaning, put the filters back in place.

Filter of Main Machine Driving Section 3M31

Every 3 Months Cleaning

Clean the filter with a vacuum cleaner.

555

Air Filter of Oil Cooler 1W11

Weekly Cleaning

Detach the filter and clean it with an air gun or

wash with water.

After cleaning, put the filter back in place.

(a) After the filter is detached, blow off dirt

and dust on the fin surfaces with an

air gun.

(b) If the filter is kept dirty, the machine

will break down.

Note

Cooling Fans of Feeder Carriage Sections 3M33

Every 3 Months Cleaning

Clean the finger guards located above and under

the cooling fan filters with a vacuum cleaner.

Fig. 4A55

Fig. 4A56

Fig. 4A57 Top View of Machine