4OM-1003-007.pdf - 第137页

0305-001 1-71 AIL01ETRP 1.4 Maintenance Method (2) When the [Start Oil Supply] button is pressed in the "Oil Supply" tab sheet, the following sheet appears. Fig. 4A85-2 (3) Press the [ALL] button (entitled &quo…

1.4.9 Lubrication of Linear Guide in Feeder Carriage Section

Grease should be applied every 6 months after the initial month.

••

• Preparation for Lubrication

(1) Turn off the power supply to the machine and wipe off old grease

on the rail of the linear guide with a rag.

(2) Prepare the FL- and P-type or the U- and P-Type attachments.

Fig. 4A85

••

• Lubrication Procedure

The linear guide in the feeder carriage section must

be lubricated with the [POWER ON] button on the

operation panel being pressed ("ON" condition).

It is dangerous. Be sure to lubricate alone (without

any other attended personnel).

(1) Press the [UNIT ADJ.] button on the submenu bar of the "MAINT."

window. After that, press the "Oil Supply" tab in the "Fdr Crg" tab

sheet. The following tab sheet appears.

Fig. 4A85-1

0511-003 1-70 AIL01ETRP

1.4 Maintenance Method

FL Type

P Type

U Type

CAUTION

0305-001 1-71 AIL01ETRP

1.4 Maintenance Method

(2) When the [Start Oil Supply] button is pressed in the "Oil Supply" tab

sheet, the following sheet appears.

Fig. 4A85-2

(3) Press the [ALL] button (entitled "ZERO"). In two seconds, press the

[ENABLE] button on the operation panel. All devices are zeroed.

(4) Press the [F1] and [F2] buttons (entitled "FEEDER READY").

0305-001 1-72 AIL01ETRP

1.4 Maintenance Method

(5) Press the [ON] button (entitled "MOVE"). In two seconds, press the

[ENABLE] button on the operation panel.

Auto tuning of all axis takes place.

(The feeder carriage moves slightly.)

(6) Press the [ON] button (entitled "MOVE"). In two seconds, press the

[ENABLE] button on the operation panel.

F1 moves to the grease supply position and the following sheet

appears.

Fig. 4A85-3

(7) Press the [EMERGENCY STOP] switch and open the F1 and cen-

tral doors.

Apply grease to the nipple on the slide block of a linear guide.

After that, close the F1 and central doors.

Grease Supply Hole Position