印刷机通用说明书(中英文版） 450+.pdf - 第45页
- 44 - Pix3-8
- 44
-
Pix3-8
- 46
-
注：Notice:
A．
[
钢网夹紧阀
]
：侧夹钢网；
(ClampSwitch): Side clip steel mesh
B．
[
钢网装载
]
：把钢网拖到Y向位置
(Stencil AutoLoad):Dray the steel mesh to the
Yposition
C
．
[
清空标志点
]
：把所有Mark点坐标全部清除；
(delete all mark): Clear the coordinates of all mark points.
C
．
[
增加防呆点
]
：防止板放反增加一个标志点
(PolarizingMark): Add a mark point to prevent
the board from being reversed
E
．
[
宽度调节
]
：对进行运输导轨宽度调节；
(width adjustment): To adjust the width of transmission rail.
F．[移动挡板气缸]：将 CCD 移动到设置的坐标上去；
(remove damper cylinder): Remove CCD to the setup position
G．[网框固定阀]：自动定位钢网的时候，点击该按钮机器会松开钢网支撑架，用手将钢网
架移到指定位置，并夹紧；
(frame fixed valve):Clicking this button when do the stencil’s automatic positioning,
the equipment will loose the support frame and remove the stencil supporting frame
to the designated spot and fix it by hand.
H．[钢网定位]：自动定位钢网的时候，钢网自动气缸会随刮刀横梁移动到指定的位置，并
伸出气缸杆，将钢网插到气缸杆位置后点击[确定]，系统重新将钢网锁紧；
(stencil positioning): When do the stencil’ automatic positioning, the stencil automatic
cylinder will move to the designated spot along with scraper beam and will release
cylinder guide. Plug the stencil into cylinder guide and click “确定 ”（ok）button, the
system will re-fasten the stencil.
I． [钢网微调]：当钢网定位位置不准确时，可点击此按钮并用鼠标调整挡钢网气缸位置。
(stencil fine adjustment ): When the positioning of the stencil is not correct, click this
button and adjust the position of stencil cylinder with mouse.
J．[刮刀后退]：让刮刀后退到后起点位置，手工对钢网的时候使用；
(scraper back ): Let scraper comes back to the starting position at the back. Do it
when operate manually on the stencil.
K．[Z 轴上升]：Z 轴上升到印刷位置。手工对钢网的时候使用，看焊盘和网孔是否对正；
(Z axis lifts up): Z axis lifts up to the printing position. Do it when operate manually on