Printer 710_810 v8 Transportation.pdf - 第29页

TRANS PORTATION MAJOR RELO CATION Chapter Issue 7 Oct 06 Technical Reference Manual 34.29 3. Maint aining hol d of the s ocket 14SK07 (t o prevent t he socket f rom fall ing into the machin e through the hole), di sconne…

100%1 / 120
TRANSPORTATION
MAJOR RELOCATION
34.28 Technical Reference Manual Chapter Issue 7 Oct 06
Tricolour Beacon
(Gull Wing and
Shutter Cover
Design)
1. Disconnect the tricolour beacon connection 14PL07 from 14SK07.
2. Remove the tricolour beacon from the beacon bracket by undoing one of the
nuts and sliding the beacon out of the cut-out on the beacon bracket.
3. Cable tie the loose cable to the cover frame.
Tricolour Beacon
(Metal Cover
Design)
1. Using a 3mm Allen key, remove the beacon bracket from the machine cover.
2. Pull the cable up through the hole to reveal the connector.
Beacon Bracket
Tricolour Beacon
Beacon Securing Nut
Beacon Bracket Cut-Out
Beacon Bracket Securing
Screws (in 4 positions)
TRANSPORTATION
MAJOR RELOCATION
Chapter Issue 7 Oct 06 Technical Reference Manual 34.29
3. Maintaining hold of the socket 14SK07 (to prevent the socket from falling
into the machine through the hole), disconnect the tricolour beacon connec-
tion 14PL07 from 14SK07.
4. Place the socket 14SK07 in the cut-out on the cover.
5. Refit the four beacon bracket securing screws.
Beacon Bracket
Securing Screws
(in 4 positions)
Beacon Connector
(14SK07)
View on Right Hand Side of the Machine
TRANSPORTATION
MAJOR RELOCATION
34.30 Technical Reference Manual Chapter Issue 7 Oct 06
Removal of the MMI
Assembly (Sliding
Glass Cover)
If the machine is being relocated in a DEK machine crate, the MMI assembly
must be wrapped securely in bubble wrap or removed from the machine using
the following procedure:
1. Remove the following connections on the rear of the monitor:
• Monitor Power Cable (DC)
• VGA Cable
• Touchscreen Cable (USB)
2. Remove the IR receiver unit (secured with velcro) from the bracket above
the monitor.
3. Remove the touchscreen stylus from the monitor arm.
4. Remove the monitor from the monitor arm by removing the four fixing
screws.
5. Remove the monitor arm by removing the three screws that secure the
monitor arm to the machine.
6. Locate the 4 port USB hub secured to the left side of the mains isolator
switch bracket.
Monitor Fixing Screws
Monitor Fixing
Screws
Touchscreen Stylus
IR Receiver Unit
DC Connection
Touchscreen
Connection
(USB)
IR Receiver Unit Cable
VGA Connection
USB Flash Drive