Printer 710_810 v8 Transportation.pdf - 第54页
TRANSPORT ATION MAJOR RE LOCATION 34.54 Technical Reference Manual Chapter Issue 7 Oct 06 T ransit Bracket s and Screws CAUTION T RAN SIT BRACKET AND SCREW REMOVAL. All transit brac ket s and screws must be remov ed from…
TRANSPORTATION
MAJOR RELOCATION
Chapter Issue 7 Oct 06 Technical Reference Manual 34.53
Grease Protection Before the machine was packaged, some areas within the machine were coated
with LM grease or WD40 to protect the metal surfaces from corroding during
transportation.
Using a lint free cloth, remove any surplus grease from the following areas,
ensuring that a light coating remains:
• Print carriage linear bearing guides (above the printheads)
• Camera linear bearing guides (below the printheads)
• Rear moving rail linear bearing guides (either side of the rising table)
• Top face of both clatter bars (either side of the rising table)
• Actuator striker plates (in 3 positions)
Figure 34-19 Grease Protection
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
The front and rear board clamp foils are greased for protection during transpor-
tation. This grease protection must to be removed completely using a lint free
cloth.
The manual tooling plate on the rising table was coated with WD40 for trans-
portation. Using a lint free cloth, wipe the manual tooling plate to remove any
residue.
Print Carriage Linear Bearing Guides
Moving Rail Linear Bearing Guide (in 2 positions)
Clatter Bar (in 2 positions)
Board Clamp
(in 2 positions)
Camera Linear Bearing Guide
(in 2 positions)
Manual Tooling Plate
Actuator (in 3 positions)
Actuator Striker Plate
(in 3 positions)
TRANSPORTATION
MAJOR RELOCATION
34.54 Technical Reference Manual Chapter Issue 7 Oct 06
Transit Brackets and Screws
CAUTION
TRANSIT BRACKET AND SCREW REMOVAL. All transit brackets and screws
must be removed from the machine before power is applied. Machine
damage may occur if transit brackets or screws are not removed prior to
power up. Transit brackets and screws are painted red for easy identifi-
cation.
Overview Transit brackets and screws are fitted to the machine to prevent the various
machine assemblies moving during transit, these are:
• Front and rear transit brackets
• Rear chase transit bracket
• Squeegee transit screws
• Print carriage transit screw
• Paste dispenser transit screw (if applicable)
• Camera transit screws
TRANSPORTATION
MAJOR RELOCATION
Chapter Issue 7 Oct 06 Technical Reference Manual 34.55
Figure 34-20 Transit Bracket and Screw Location
Rear Transit Bracket
Front Transit Bracket
Squeegee Transit Screws
Print Carriage Transit Screw
Camera Transit Screws
(rotary drive only)