80S-2080F480F5.pdf - 第482页
9 Maintenance SIPLACE 80 S-20/F4/F5 User Manual 9.2 Maintenance Schedules 05/99 Issue from Software V ersion SR.405.xx 9 - 16
SIPLACE 80S-20/F4/F5 User Manual 9 Maintenance
05/99 Issue from Software Version SR.405.xx 9.2 Maintenance Schedules
9 - 15
9.2.3 Additional Maintenance for the SIPLACE 80F
5
Placement
Machine
FC camera
Clean reflective surfaces and
glass disk
Soft, grease-free
brush, cloth for
cleaning optical
equipment
Coplanarity
module
Clean glass disk
Soft, grease-free
brush, cloth for
cleaning optical
equipment
Waffle-pack
changer
Guide rails and tray stor-
age unit
Remove abrasion deposits Damp, lint-free cloth
Module Subassembly
To be carried out weekly
(15/17 shifts)
Equipment
Date
done
Empty tape
cutter for 80F
5
Cutter blade Vacuum clean Vacuum cleaner
Tab. 9.2.13 Additional maintenance for the SIPLACE 80F
5
: To be carried out weekly
Module Subassembly
To be carried out monthly
(60/70 shifts)
Equipment
Date
done
Empty tape
cutter for 80F
5
Moving
cutter blade
Apply lubricant and corrosion
inhibiting agent to the sliding sur-
face between the moving cutter
blade and the retainer
WD-40
Tab. 9.2.14 Additional maintenance for the SIPLACE 80F
5
: To be carried out monthly
Module Subassembly To be carried out as required Equipment
Date
done
Empty tape
cutter for 80F
5
Cutter blade
Change the cutting edges or replace
the cutter blade
Hexagon socket
screw key
Tab. 9.2.15 Additional maintenance for the SIPLACE 80F
5
: To be carried out as required
Module Subassembly To be carried out as required Equipment
Date
done
Tab. 9.2.12 Additional maintenance for the SIPLACE 80F
4
/F
5
: To be carried out as required
9 Maintenance SIPLACE 80S-20/F4/F5 User Manual
9.2 Maintenance Schedules 05/99 Issue from Software Version SR.405.xx
9 - 16
SIPLACE 80S-20/F4/F5 User Manual 9 Maintenance
05/99 Issue from Software Version SR.405.xx 9.3 Machine Base
9 - 17
9.3 Machine Base
DANGER
Do not carry out any cleaning work with alcohol in the presence of naked lights or fire!
NOTE
Carry out all maintenance work on the machine base in the same way for both the SIPLACE 80S-20 and the
80F
4
or 80F
5
machines, as described below unless the text specifies otherwise for a particular machine type.
9.3.1 Control Unit or Servo Unit
9.3.1.1 Cleaning and Replacing the Filter Mats
NOTE
If the filter mats are dirty, adequate cooling of the electronics modules will no longer be assured.
Spare parts you may need
Viledon filter mats 225 x 362, from item no.
00304048-01
Switch the machine off at the main switch.
Open the doors in the machine base (see Fig. 9.3.1).
Pull the filter mats (under the servo and control units) out between the unit and base plate of the machine
base.
Clean the filter mats thoroughly on both sides with the vacuum cleaner.
Push the filter mat back into the plug-in unit or replace it, if necessary.
Close the control and servo cabinet doors and switch the machine on at the main switch.
Make sure that the fan motors are functioning by holding a sheet of paper, for example, under the opening
in the base plate.